Nissan Murano: Automatic Back Door Operation Does Not Operate / Open Function

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Door & Lock :: Symptom Diagnosis / Automatic Back Door Operation Does Not Operate / Open Function

Diagnosis Procedure

Back door auto closure function does not operate when back door opening operations are performed.

CHECK BACK DOOR OPENER SWITCH

Check back door opener switch.

Refer to Component Function Check.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace the malfunctioning parts.

REPLACE AUTOMATIC BACK DOOR CONTROL MODULE

Replace automatic back door control module. Refer to Removal and Installation.
Confirm the operation after replacement.

Is the result normal?

YES>>

Inspection End.

NO>>

Check intermittent incident. Refer to Intermittent Incident.

Open/closure Function

Diagnosis Procedure Back door auto closure function does not operate when back door opening and closing operations are performed.CHECK DTC WITH AUTOMATIC BACK DOOR CONTROL MODULE Check that DTC is not detected with automatic back door control module...

Closure Function

Diagnosis Procedure Back door auto closure function does not operate when back door closing operations are performed.CHECK HALF LATCH SWITCH Check half latch switch...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: C1a12 Laser Beam Off Center

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition C1A12–78 LASER BEAM OFFCNTR Diagnosis condition When Ignition switch is ON. Signal (terminal) — Threshold Radar of distance sensor (ICC sensor) is off the aiming point...

Nissan Murano (Z52) 2015-2024 Service Manual: U1010 Control Unit(can)

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1010 CONTROL UNIT (CAN) [CONTROL UNIT (CAN)] Diagnosis condition When ignition switch is ON. Signal (terminal) - Threshold - Diagnosis delay time 2 seconds or more POSSIBLE CAUSECombination meterFAIL-SAFEThe combination meter activates the fail-safe control if CAN communication with each unit is malfunctioning...