Nissan Murano: Automatic Back Door Operation Does Not Operate / Open/closure Function
Back door auto closure function does not operate when back door opening and closing operations are performed.
CHECK DTC WITH AUTOMATIC BACK DOOR CONTROL MODULE
Check that DTC is not detected with automatic back door control module.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Perform trouble diagnosis relevant to DTC indicated.
CHECK BACK DOOR OPENER SWITCH
Check back door opener switch.
Refer to Component Function Check.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace the malfunctioning parts.
CHECK BACK DOOR CLOSURE MOTOR
Check back door closure motor.
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Repair or replace the malfunctioning parts.
REPLACE AUTOMATIC BACK DOOR CONTROL MODULE
-
Replace automatic back door control module. Refer to Removal and Installation.
-
Confirm the operation after replacement.
Is the result normal?
YES>>Inspection End.
NO>>Check intermittent incident. Refer to Intermittent Incident.
Intelligent Key
Diagnosis Procedure
Automatic back door open/close function does not operate using Intelligent Key.NOTE:
Automatic back door open/close operation condition is extremely complicated...
Open Function
Diagnosis Procedure
Back door auto closure function does not operate when back door opening operations are performed.CHECK BACK DOOR OPENER SWITCH
Check back door opener switch...
Other information:
Nissan Murano (Z52) 2015-2024 Owners Manual: RAB system limitations
WARNING Listed below are the system limitations for the RAB system. Failure to follow the warnings and instructions for proper use of the RAB system could result in serious injury or death. When the vehicle approaches an obstacle while the accelerator or brake pedal is depressed, the function may not operate or the start of operation may be delayed...
Nissan Murano (Z52) 2015-2024 Service Manual: Ecu Diagnosis Information. 3ch Can Gateway
Reference Value TERMINAL LAYOUTPHYSICAL VALUES Terminal No. (Wire color) Description Condition Standard Reference value + – Signal name Input/ Output 1 (L) — Nissan Murano Vehicle CAN communication-H Input/ Output — — — 2 (P) — Nissan Murano Vehicle CAN communication-L Input/ Output — — — 3 (L) — Diagnostic CAN communication-H Input/ Output — — — 4 (P) — Diagnostic CAN communication-L Input/ Output — — — 5 (BG) 6 (B) 7 (B) Ignition power supply Input Ignition switch ON 7 – 16 V Battery voltage 8 (BG) 6 (B) 7 (B) Battery power supply Input Ignition switch OFF 6 – 16 V Battery voltage 9 (L) — IT CAN communication-H — — — — 10 (P) — IT CAN communication-L — — — — 11 (L) — Diagnostic CAN communication-H Input/ Output — — — 12 (P) — Diagnostic CAN communication-L Input/ Output — — — 13 (L) — IT CAN communication-H — — — — 14 (P) — IT CAN communication-L — — — — DTC Inspection Priority Chart If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Passenger compartment
- Shift lock release
- System malfunction
- New on site
- Most important about car
Fuel gauge
The gauge indicates the approximate fuel level in the tank.
The gauge may move slightly during braking, turning, acceleration, or going up or down hills.
The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.
