Nissan Murano: Door & Lock :: Symptom Diagnosis / Integrated Homelink Transceiver Does Not Operate

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Door & Lock :: Symptom Diagnosis / Integrated Homelink Transceiver Does Not Operate

Diagnosis Procedure

CHECK INTEGRATED HOMELINK^® TRANSCEIVER

Check integrated HomeLink^® transceiver.

Refer to Component Function Check.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace the malfunctioning parts.

REPLACE AUTO ANTI-DAZZLING INSIDE MIRROR

Replace auto anti-dazzling inside mirror.

Refer to Removal and Installation.

Is the result normal?

YES>>

Inspection End.

NO>>

Check intermittent incident. Refer to Intermittent Incident.

Motion Activated Back Door Does Not Operate Properly

Diagnosis Procedure Automatic back door open/close function does not operate properly when using motion activated back door sensor.CHECK BATTERY Check the vehicle battery condition...

Squeak and Rattle Trouble Diagnoses

Work Flow CUSTOMER INTERVIEWInterview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any customer's comments; refer to Diagnostic Worksheet...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P0706 Transmission Range Sensor a

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0706 T/M RANGE SENSOR A (Transmission Range Sensor A Circuit Range/Performance) Diagnosis condition TCM power supply voltage: More than 11 V Signal Transmission range switch signal Threshold All range signals stay OFF Diagnosis delay time Maintained for 30 seconds POSSIBLE CAUSE Harness or connector (Open circuit between ignition switch and transmission range switch/open circuit between transmission range switch and TCM) Transmission range switch Control cable Harness or connector (CAN communication line is error)FAIL-SAFE Shift position indicator on combination meter is not displayed Selector shock is large Start is slow Acceleration is slow Lock-up is not performed DTC Confirmation Procedure PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test...

Nissan Murano (Z52) 2015-2024 Service Manual: Seat Belt Warning

Seat Belt Warning Chime SYSTEM DIAGRAMWARNING OPERATION CONDITIONSFront Seat BeltsIf all of the following conditions are fulfilled: Operation conditions Ignition switch ON Nissan Murano Vehicle speed Approximately 9.3 mph (15 km/h) or more. Front seat belt buckle switch LH Unfastened (front seat belt buckle switch LH ON) Front seat belt buckle switch RH Front passenger seat is occupied, seat belt unfastened (front seat belt buckle switch RH ON)...