Nissan Murano: Maintenance and schedules / Maintenance under severe operating conditions

Nissan Murano (Z52) 2015-2024 Owners Manual / Maintenance and schedules / Maintenance under severe operating conditions

The maintenance intervals shown on the preceding pages are for normal operating conditions. If the vehicle is mainly operated under severe driving conditions as shown below, more frequent maintenance must be performed on the following items as shown in the table.

Maintenance operation: Inspect = Inspect and correct or replace as necessary.

Nissan Murano. Maintenance under severe operating conditions

SEVERE DRIVING CONDITIONS

  • Repeated short trips of less than 5 miles (8 km).
  • Repeated short trips of less than 10 miles (16 km) with outside temperatures remaining below freezing.
  • Operating in hot weather in stopand- go “rush hour” traffic.
  • Extensive idling and/or low speed driving for long distance, such as police, taxi or door-to-door delivery use.
  • Driving in dusty conditions.
  • Driving on rough, muddy or salt spread roads.
  • Towing a trailer, using a camper or using a car-top carrier.

    Chassis & body maintenance

    Abbreviations: I = Inspect and correct or replace as necessary, R = Replace, NOTE: Maintenance items with “ ” should be performed more frequently according to “Maintenance under severe driving conditions”...

    Maintenance log

    ..

    Other information:

    Nissan Murano (Z52) 2015-2024 Owners Manual: Maximum trailer loads


    Never allow the total trailer load to exceed the value specified in the “Towing Load/Specification” chart found in this section. The total trailer load equals trailer weight plus its cargo weight. The maximum Gross Combined Weight Rating (GCWR) should not exceed the value specified in the following Towing Load/Specification Chart...

    Nissan Murano (Z52) 2015-2024 Service Manual: C1b0a-16 Power Supply Circuit2


    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1B0A-16 POWER SUPPLY CIRCUIT2 (Power supply circuit) Diagnosis condition When ignition switch is ON. Signal (terminal) - Threshold Lane camera unit ignition voltage is less than 10...

    Categories

    read more

     
    Copyright © 2026 www.nimurano.com