Nissan Murano: Door Request Switch / Back Door
Removal and Installation
REMOVAL
Remove back door outer finisher. Refer to Removal and Installation.
Disconnect the harness connector from the back door request switch.
Release pawls and remove back door request switch.
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
The passenger side door request switch and passenger side outside handle are serviced as an assembly. Refer to Removal and Installation...
Other information:
NVH Troubleshooting Chart
Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. Reference — Inspection — Exploded View — Inspection NVH Troubleshooting Chart Inspection NVH Troubleshooting Chart NVH Troubleshooting Chart Inspection NVH Troubleshooting Chart NVH Troubleshooting Chart
Possible cause and SUSPECTED PARTS Excessive joint angle Joint sliding resistance Imbalance Improper installation, looseness Parts interference Wheel bearing damage FRONT SUSPENSION FRONT AXLE TIRE WHEEL DRIVE SHAFT BRAKE STEERING
Symptom
DRIVE SHAFT
Noise
×
×
-
-
-
×
×
×
×
×
-
×
×
Shake
×
-
×
-
-
×
×
×
×
×
-
×
×
FRONT AXLE
Noise
-
-
-
×
×
×
×
×
×
×
×
×
Shake
-
-
-
×
×
×
×
×
×
×
×
×
Vibration
-
-
-
×
×
×
×
-
×
-
×
-
×
Shimmy
-
-
-
×
×
-
×
-
×
×
-
×
×
Shudder
-
-
-
×
-
×
-
×
×
-
×
×
Poor quality ride or handling
-
-
-
×
×
-
×
-
×
×
-
-
-
Inspect Front Axle for cracks or damage...
Description
This procedure must be performed after replacement of a tire pressure sensor or BCM.
Work Procedure
TPMS ID registration can be performed using one of the following procedures:
Transmitter Activation tool [KV48105501 (J-45295-A)] using CONSULT (preferred method)
Signal Tech II tool [– (J-50190)] with CONSULT (preferred method)
Signal Tech II tool [– (J-50190)] without CONSULT
CONSULT only
TPMS REGISTRATION WITH TRANSMITTER ACTIVATION TOOL [KV48105501 (J-45295-A)]CONSULT
Ignition switch ON...