Nissan Murano: Periodic Maintenance / Idle Speed

Nissan Murano (Z52) 2015-2024 Service Manual / Engine / Engine Control System :: Vq35de / Periodic Maintenance / Idle Speed

Work Procedure

CHECK IDLE SPEED

With CONSULT

Check idle speed in “DATA MONITOR” mode with CONSULT.

With GST

Check idle speed with Service $01 of GST.

>>

INSPECTION END

    Periodic Maintenance

    ..

    Ignition Timing

    Work Procedure CHECK IGNITION TIMING Attach timing light to loop wires as shown. (A) : Timing light : Nissan Murano Vehicle front Check ignition timing...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Intelligent Key System Symptoms


    Diagnosis Procedure NOTE: Perform the self diagnosis result with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. SYMPTOM TABLE 1 (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) No. Door lock operation (remote keyless entry) Door lock operation (request switch) or back door open operation (opener switch of back door panel) Engine started with ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) Engine started with ignition switch operation (registered Intelligent Key placed next to ignition switch) Symptom 1 OK OK No start No start Diagnosis Procedure 2 OK NG OK OK Diagnosis Procedure 3 OK NG No crank, No start OK Diagnosis Procedure 4 NG NG No crank, No start OK Diagnosis Procedure 5 NG NG No start No start Diagnosis Procedure 6 OK OK No crank, No start OK Diagnosis Procedure 7 NG OK OK OK Diagnosis Procedure 8 NG NG OK OK Diagnosis Procedure 9 Poor range OK OK OK Diagnosis Procedure SYMPTOM TABLE 2 (ONE INTELLIGENT KEY HAS THE SYMPTOM, OTHER KEYS OPERATE NORMALLY) No...

    Nissan Murano (Z52) 2015-2024 Service Manual: Preparation. Preparation


    Special Service Tools The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description A. — (J-52389) Engine support tool B. — (J-52604) Engine support bracket Supporting engine — (J-51307) CVT transmission jack adapter Removing CVT KV311039S0 ( — ) Charging pipe set KV31103920* ( — ) O-ring CVT fluid changing and adjustment ( — ) (J-52584) CVT stand pipe adapter kit CVT fluid changing and adjustment KV38107900 (J-52469–1) Differential side oil seal protector Installing drive shaft A: 32 mm (1...

    Categories

    Fuel gauge

    Nissan Murano. Fuel gauge

    The gauge indicates the approximate fuel level in the tank.

    The gauge may move slightly during braking, turning, acceleration, or going up or down hills.

    The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.

    read more

     
    Copyright © 2026 www.nimurano.com