Nissan Murano: Removal and Installation / Front Fog Lamp

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Controls / Exterior Lighting System :: Led Headlamp / Removal and Installation / Front Fog Lamp

Exploded View

1. Front fog lamp 2. Front bumper fascia A. Front fog lamp harness connector
Removal and Installation

REMOVAL

Partially remove front fender protector. Refer to Exploded View.

Disconnect harness connector from front fog lamp.

Remove front fog lamp bolts and front fog lamp.

INSTALLATION

Installation is in the reverse order of removal.

Bulb Replacement

The fog lamp bulb is LED and not serviced separately. Refer to Removal and Installation.

    Front Combination Lamp

    Exploded View 1. Front combination lamp Removal and Installation REMOVALRemove front bumper fascia. Refer to Removal and Installation. Remove front combination lamp bolts...

    Door Mirror Turn Signal Lamp

    R..

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: B260a Ignition Relay


    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition B260A IGNITION RELAY (Ignition relay) Diagnosis condition When ignition switch ON. Signal (terminal) — Threshold — Diagnosis delay time 2 seconds or more POSSIBLE CAUSE Harness or connectors BCM IPDM E/R FAIL SAFE— DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON under the following conditions and wait for at least 2 seconds: CVT selector lever is in the P (park) or N (neutral) position...

    Nissan Murano (Z52) 2015-2024 Owners Manual: Top tether anchor


    WARNING Do not allow cargo to contact the top tether strap when it is attached to the top tether anchor. Properly secure the cargo so it does not contact the top tether strap.Cargothat is not properly secured or cargothat contacts the top tether strap may damage it during a collision...

    Categories

    Fuel gauge

    Nissan Murano. Fuel gauge

    The gauge indicates the approximate fuel level in the tank.

    The gauge may move slightly during braking, turning, acceleration, or going up or down hills.

    The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.

    read more

     
    Copyright © 2026 www.nimurano.com