Nissan Murano: Driver Controls / Horn :: Precaution. Precautions

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Controls / Horn :: Precaution. Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions.

Information necessary to service the system safely is included in the “SRS AIR BAG” and “SEAT BELT” sections of this Service Manual.

WARNING:

Always observe the following items for preventing accidental activation:

To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision that would result in air bag inflation, it is recommended that all maintenance and repair be performed by an authorized NISSAN/INFINITI dealer.

Improper repair, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see “SRS AIR BAG”.

Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:

Always observe the following items for preventing accidental activation:

When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the ignition/power switch ON or engine running, never use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.

When using air or electric power tools or hammers, always switch the ignition/power switch OFF, disconnect the 12V battery or batteries, and wait at least 3 minutes before performing any service.

Condenser

Removal and Installation REMOVALRemove the back door lower finisher. Refer to Removal and Installation. Disconnect the harness connectors (A) from the condenser (1)...

Horn :: Removal and Installation. Horn

Exploded View 1. Horn (LOW) 2. Horn (HIGH) Removal and Installation REMOVALRemove the front grille. Refer to Removal and Installation. Disconnect the harness connectors from the horns (LOW, HIGH)...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Parking Brake Rear Cable

Removal and Installation REMOVALRemove center console assembly. Refer to Removal and Installation. Loosen adjusting nut. Refer to Exploded View. NOTE: It is not necessary to remove parking brake front cable. Pull equalizer (A) on parking brake front cable (1) in a rearward direction and then push upward to separate each parking brake rear cable (2) from the parking brake front cable (1)...

Nissan Murano (Z52) 2015-2024 Service Manual: Battery Saver Output/power Supply Circuit

Component Function Check CHECK INTERIOR ROOM LAMP POWER SUPPLY FUNCTION CONSULT Ignition switch ON. Turn each interior room lamp ON. Personal lamp 2nd row LH Personal lamp 2nd row RH Front room/map lamp assembly Luggage room lamp Vanity lamp LH Vanity lamp RH Select “BATTERY SAVER” in “Active Test” mode of “BCM(BATTERY SAVER)”...