Nissan Murano: Symptom Diagnosis / Heavy Tight-Corner Braking Symptom Occurs

Nissan Murano (Z52) 2015-2024 Service Manual / Transmission & Driveline / Driveline :: Transfer: Ty21c / Symptom Diagnosis / Heavy Tight-Corner Braking Symptom Occurs

Diagnosis Procedure

Heavy tight-corner braking symptom occurs when the vehicle is driven and the steering wheel is turned fully to either side after the engine is started.

NOTE:

Light tight-corner braking symptom may occur depending on driving conditions. This is not malfunction.

SELECT SELF DIAGNOSTIC RESULT 1

CONSULT

Select “Self Diagnostic Result” mode of “ENGINE”.

Is any DTC detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

GO TO 2.

SELECT SELF DIAGNOSTIC RESULT 2

CONSULT

Select “Self Diagnostic Result” mode of “ALL MODE AWD/4WD”.

Is DTC “U1000” detected?

YES>>

Proceed to Trouble Diagnosis Flow Chart.

NO>>

GO TO 3.

CHECK AWD SOLENOID

Perform the trouble diagnosis of the AWD solenoid. Refer to DTC Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace the error-detected parts.

CHECK ELECTRIC CONTROLLED COUPLING

  1. Ignition switch OFF.

  2. Set the transaxle to neutral. Release the parking brake.

  3. Lift up the Nissan Murano vehicle.

  4. Rotate the propeller shaft by hand.

  5. Hold rear wheel of right and left lightly.

Does rear wheel rotate?

YES>>

Replace electric controlled coupling for mechanical malfunction (clutch sticking etc.). Refer to Removal and Installation.

NO>>

Check each harness connector pin terminal for disconnection.

    Awd Error Is Displayed on Information Display

    Diagnosis Procedure AWD warning icon/display (AWD Error: See Owner′s Manual) is displayed on information display after the engine started.SELECT SELF DIAGNOSTIC RESULT CONSULT Select “Self Diagnostic Result” mode of “ALL MODE AWD/4WD”...

    Vehicle Does Not Enter Awd Mode

    Diagnosis Procedure Vehicle does not enter 4-wheel drive mode even though AWD warning icon/display is not displayed.CHECK AWD WARNING ICON/DISPLAY Perform the trouble diagnosis of the AWD warning icon/display...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Diagnosis and Repair Workflow


    Work Flow OVERALL SEQUENCEDETAILED FLOWGET INFORMATION FOR SYMPTOM Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred). >> GO TO 2. CONFIRM THE SYMPTOM Try to confirm the symptom described by the customer...

    Nissan Murano (Z52) 2015-2024 Service Manual: Configuration (adas Control Unit)


    Description Since vehicle specifications are not included in the ADAS control unit after replacement, it is required to write Nissan Murano vehicle specifications using CONSULT. Configuration has three functions as follows: Function Description Read/Write Configuration Before ECU Allows the reading of Nissan Murano vehicle specification written in ADAS control unit to store the specification in CONSULT...

    Categories

    LATCH (Lower Anchors and Tethers for CHildren) system

    Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

    LATCH system lower anchor locations - bench seat

    Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.

    read more

     
    Copyright © 2026 www.nimurano.com