Nissan Murano: Security Control System :: Dtc/circuit Diagnosis / Headlamp Function
Component Function Check
CHECK FUNCTION
CONSULT
-
Select the "HEAD LAMP(HI)" in "Active Test" mode of "BCM(THEFT ALM)".
-
Check headlamps operation.
| Test item | Description |
| HEAD LAMP (HI) |
ON |
Headlamps (Hi) |
Light |
| OFF |
Do not light |
Is the inspection result normal?
YES>>
Inspection End.
NO>>
Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK HEADLAMP FUNCTION
Refer to Component Function Check.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident.
>>
Inspection End.
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition
B26FC
KEY REGISTRATION
(Key registration)
Diagnosis condition
When ignition switch is ON...
Component Function Check
CHECK FUNCTION
CONSULT
Select “HOOD SW” and “HOOD SW 2” in “Data Monitor” mode of “IPDM E/R”.
Check “HOOD SW” and “HOOD SW 2” indication under the following condition:
Monitor item Condition Indication
HOOD SW
Hood
Open
OFF
Close
ON
HOOD SW 2
Open
ON
Close
OFF
Is the indication normal?
YES>>
Hood switch is OK...
Other information:
Push the switch on to warn other drivers
when you must stop or park under emergency
conditions. All turn signal lights flash.
WARNING
If stopping for an emergency, be sure
to move the vehicle well off the road.
Do not use the hazardwarning flashers
while moving on the highway unless
unusual circumstances force you to
drive so slowly that your vehicle might
become a hazard to other traffic...
Component Parts Location
No. Component Function
1.
Rear sonar sensor RH inner
Refer to Sonar Sensor.
2.
Rear sonar sensor RH outer
3.
Around view monitor control unit (if equipped)
Around view monitor control unit transmits the setting change request signal to sonar control unit via CAN communication...