Nissan Murano: Security Control System :: Dtc/circuit Diagnosis / B26fc Key Registration
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B26FC |
KEY REGISTRATION (Key registration) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | — | ||
| Threshold | Intelligent Key that does not match the Nissan Murano vehicle is registered | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
-
Improper registration operation
-
Intelligent Key
-
BCM
FAIL-SAFE
—
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Perform initialization of BCM and reregistration of all Intelligent Keys. Refer to Work Procedure.
-
Select “Self Diagnostic Result” mode of “BCM”.
-
Check DTC.
Is DTC detected?
YES>>Refer to Diagnosis Procedure.
NO>>Inspection End.
REPLACE INTELLIGENT KEY
CONSULT
-
Prepare Intelligent Key that matches the Nissan Murano vehicle.
-
Perform initialization of BCM and registration of Intelligent Key. Refer to Work Procedure.
-
Select “Self Diagnostic Result” mode of “BCM”.
-
Check DTC.
Is DTC detected?
YES>>GO TO 2.
NO>>Inspection End.
REPLACE BCM
-
Replace BCM. Refer to Removal and Installation.
-
Perform initialization of BCM and registration of all Intelligent Keys. Refer to Work Procedure.
>>
Inspection End.
B26f7 Bcm
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition
B26F7
BCM
(Body control module)
Diagnosis condition
When ignition switch is ON...
Headlamp Function
Component Function Check
CHECK FUNCTION
CONSULT
Select the "HEAD LAMP(HI)" in "Active Test" mode of "BCM(THEFT ALM)".
Check headlamps operation.
Test item Description
HEAD LAMP (HI)
ON
Headlamps (Hi)
Light
OFF
Do not light
Is the inspection result normal?
YES>>
Inspection End...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P0011 Ivt Control
DTC Description DTC DETECTION LOGICThere is a gap between angle of target and phase-control angle degree. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0011 INT/V TIM CONT-B1 (“A” Camshaft Position - Timing Over-Advanced or System Performance bank 1) Diagnosis condition — Signal (terminal) Camshaft position sensor signal Threshold During the advanced control of intake valve timing control, the angle difference between actual angle and target angle is 13 degrees or more...
Nissan Murano (Z52) 2015-2024 Owners Manual: Flat towing for front wheel drive vehicle (if so equipped)
Towing your vehicle with all four wheels on the ground is sometimes called flat towing. This method is sometimes used when towing a vehicle behind a recreational vehicle, such as a motor home. CAUTION Failure to follow these guidelines can result in severe transmission damage...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Settings
- High Beam Assist (if so equipped)
- Checking engine oil level
- New on site
- Most important about car
Seatback pockets
Theremaybe one or two seatback pockets located on the back of the driver and passenger seats. The pockets can be used to store maps.
WARNING
