Other information:
Abbreviations: I = Inspect and correct or replace as necessary, R =
Replace
NOTE:
(1) After 40,000 miles (64,000 km) or 48 months, inspect every 10,000
miles (16,000 km) or 12 months. Replace the drive belt if
found damaged.
(2) If operating mainly in dusty conditions, more frequent maintenance
may be required...
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition
C1143
ST ANG SEN CIRCUIT
(Steering angle sensor circuit)
Diagnosis condition
When ignition switch ON.
Signal (terminal)
Steering angle sensor signal
Threshold
Steering angle sensor signal failure
Diagnosis delay time
2 seconds or more
POSSIBLE CAUSE
Harness or connectors
Steering angle sensor
Power steering control module
FAIL-SAFECertain steering assist force
DTC Confirmation Procedure
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test...