Nissan Murano: Maintenance and schedules / Explanation of scheduled maintenance items
The following descriptions are provided to
give you a better understanding of the
scheduled maintenance items that should
be regularly checked or replaced. The
maintenance schedule indicates at which
mileage/time intervals each item requires
service.
In addition to scheduled maintenance,
your vehicle requires that some items be
checked during normal day-to-day operation.
For additional information, refer to
“General maintenance” in this section.
Items marked with
are
recommended
by NISSAN for reliable vehicle operation.
You are not required to perform maintenance
on these items in order to maintain
the warranties which come with your
NISSAN. Other maintenance items and intervals
are required.
When applicable, additional information
can be found in the “Do-it-yourself” section
of this manual.
NOTE:
NISSAN does not advocate the use of
non-OEM approved aftermarket flushing
systems and strongly advises
against performing these services on a
NISSAN product. Many of the aftermarket
flushing systems use non-OEM approved
chemicals or solvents, the use of
which has not been validated by NISSAN.
For recommendedfuel, lubricants, fluids,
grease, and refrigerant, refer to “Recommended
fluids/lubricants and capacities”
in the “Technical and consumer information”
section of this manual.
The maintenance items listed here should
be checked periodically (for example, each
time you check the engine oil or refuel).
Battery* (for maintenance free batteries):
This vehicle is equipped with a sealed
maintenance free battery...
Drive belt*: Check engine drive belt for
wear, fraying or cracking and for proper
tension. Replace any damaged drive belt.
Engine air filter: Replace at specified intervals...
Other information:
Removal and Installation
REMOVALRemove main power window and door lock/unlock switch finisher. Refer to Removal and Installation.
Release pawls and remove door mirror remote control switch (1) from main power window and door lock/unlock switch finisher (2)...
DTC Description
DTC DETECTION LOGICAn improper voltage is sent to the ECM through exhaust valve timing control solenoid valve. DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0078
EX V/T ACT/CIRC-B1
[Exhaust valve timing control solenoid valve (bank 1) circuit]
Diagnosis condition
Start engine and let it idle
Signal (terminal)
Voltage signal transmitted from exhaust valve timing control solenoid valve to ECM
Threshold
An improper voltage is sent to the ECM through exhaust valve timing control solenoid valve
Diagnosis delay time
—
P0084
EX V/T ACT/CIRC-B2
[Exhaust valve timing control solenoid valve (bank 2) circuit]
Diagnosis condition
Start engine and let it idle
Signal (terminal)
Voltage signal transmitted from exhaust valve timing control solenoid valve to ECM
Threshold
An improper voltage is sent to the ECM through exhaust valve timing control solenoid valve
Diagnosis delay time
—
POSSIBLE CAUSEP0078
Harness or connectors (Exhaust valve timing control solenoid valve circuit is open or shorted...