Nissan Murano: Driveline :: Transfer: Ty21c / Dtc/circuit Diagnosis

Unit Characteristics Writing

Description When replacing AWD control unit, rear final drive assembly and/or electric controlled coupling, unit characteristics of electric controlled coupling writing is required...

C1201 Controller Failure

DTC Description DTC DETECTION LOGICMalfunction has occurred inside AWD control unit. DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition C1201 CONTROLLER FAILURE (Control unit failure) Diagnosis condition Ignition switch: ON Signal — Threshold — Diagnosis delay time — POSSIBLE CAUSEInternal malfunction of AWD control unitFAIL-SAFEFront-wheel drive or shifts to 4-wheel drive (rear-wheels still have some driving torque)...

Other information:

Nissan Murano (Z52) 2015-2024 Owners Manual: Top tether anchor

WARNING Do not allow cargo to contact the top tether strap when it is attached to the top tether anchor. Properly secure the cargo so it does not contact the top tether strap.Cargothat is not properly secured or cargothat contacts the top tether strap may damage it during a collision...

Nissan Murano (Z52) 2015-2024 Service Manual: P0706 Transmission Range Sensor a

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0706 T/M RANGE SENSOR A (Transmission Range Sensor A Circuit Range/Performance) Diagnosis condition TCM power supply voltage: More than 11 V Signal Transmission range switch signal Threshold All range signals stay OFF Diagnosis delay time Maintained for 30 seconds POSSIBLE CAUSE Harness or connector (Open circuit between ignition switch and transmission range switch/open circuit between transmission range switch and TCM) Transmission range switch Control cable Harness or connector (CAN communication line is error)FAIL-SAFE Shift position indicator on combination meter is not displayed Selector shock is large Start is slow Acceleration is slow Lock-up is not performed DTC Confirmation Procedure PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test...