Nissan Murano: Mirrors :: Removal and Installation / Door Mirror

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Controls / Mirrors :: Removal and Installation / Door Mirror

Exploded View

1.	Door mirror glass	2.	Door mirror actuator	3.	Side camera (if equipped)
4.	Door mirror	5.	Door mirror rear finisher	6.	Door mirror corner finisher
7.	Side camera finisher (if equipped)	A.	Refer to Removal and Installation.		Pawl

Removal and Installation

REMOVAL

Remove front door finisher. Refer to Removal and Installation.

Remove door mirror corner finisher, then disconnect harness connector from BSW indicator (if equipped).

Disconnect harness connector from door mirror assembly.

Remove door mirror nuts and door mirror assembly.

INSTALLATION

Installation is in the reverse order of removal.

For installation, tighten door mirror nuts to specification in sequence shown.

Door mirror nuts

:5.74 N·m (0.58 kg-m, 51 in-lb)

CAUTION:

Perform camera image calibration (if equipped with intelligent around view monitor). Refer to Description (INTELLIGENT AROUND VIEW MONITOR WITH DISPLAY AUDIO SYSTEM) or Description (INTELLIGENT AROUND VIEW MONITOR WITH NAVIGATION SYSTEM).

Inside Mirror

Exploded View 1. Lane camera bracket 2. Lane camera 3. Inside mirror 4. Inside mirror finisher A. Bolt Metal clip Pawl MANUAL ANTI-DAZZLING 1...

Door Mirror Glass

Removal and Installation REMOVALApply protective tape to door mirror. Release metal clips and pawls that retain door mirror glass using a suitable tool, disconnect harness connectors (A)(if equipped) from door mirror glass and remove...

Other information:

Nissan Murano (Z52) 2015-2024 Owners Manual: Intelligent Driver Alertness (I-DA)

WARNING Failure to follow the warnings and instructions for proper use of the I-DA system could result in serious injury or death. The I–DA system is only a warning to inform the driver of a potential lack of driver attention or drowsiness...

Nissan Murano (Z52) 2015-2024 Service Manual: Parking Brake System :: Service Data and Specifications (sds). Service Data and Specifications (sds)

Parking Drum Brake Unit: mm (in) Item Limit Brake lining Thickness 3.33 (0.131) Wear thickness 1.5 (0.059) Drum Inner diameter 190 (7.480) Wear limit of inner diameter 191 (7.520) Parking Brake Control Item Standard Number of notches [under force of 196 N (20...