Nissan Murano: Removal and Installation / Distance Sensor
REMOVAL
The removal and installation of the distance sensor is located in the Cruise Control System section.
For removal and installation of the distance sensor. Refer to Removal and Installation.
Side Radar
Exploded View
1.
Side radar
2.
Rear fender
Front
NOTE:
LH shown, RH similar.
Removal and Installation
REMOVALRemove the rear bumper fascia...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Component Parts. Can Gateway System
..
Nissan Murano (Z52) 2015-2024 Service Manual: P0826 up and Down Shift Sw
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0826 UP/DOWN SHIFT SWITCH (Up and Down Shift Switch Circuit) Diagnosis condition Engine is started Signal — Threshold TCM monitors manual mode, non-manual mode, up or down switch signal, and detects as irregular when impossible input pattern occurs Diagnosis delay time 1 second or more POSSIBLE CAUSE Manual mode switch Harness or connectors (Manual mode switch circuit are open or shorted...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Intelligent Forward Collision Warning (I-FCW)
- How to enable/disable the LDW system
- Shift lock release
- New on site
- Most important about car
Luggage hooks
When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs. (29 N) to a single hook.
The luggage hooks that are located on the floor should have loads less than 110 lbs. (490 N) to a single hook.
Copyright © 2026 www.nimurano.com