Nissan Murano: Basic Inspection / Configuration (around View Monitor Control Unit)
Vehicle specification needs to be written with CONSULT because it is not written after replacing around view monitor control unit.
Configuration has three functions as follows
| Function | Description |
|---|---|
| READ CONFIGURATION |
|
| WRITE CONFIGURATION - Manual setting | Writes the Nissan Murano vehicle configuration with manual setting. |
| WRITE CONFIGURATION - Config file | Writes the Nissan Murano vehicle configuration with saved data. |
CAUTION:
-
When replacing around view monitor control unit, you must perform “WRITE CONFIGURATION” with CONSULT.
-
Never perform “WRITE CONFIGURATION” except for new around view monitor control unit.
WRITING MODE SELECTION
CONSULT
Select “CONFIGURATION” of AVM.
When writing saved data>>
GO TO 2.
When writing manually>>GO TO 3.
PERFORM “WRITE CONFIGURATION - Config file”
CONSULT
Perform “WRITE CONFIGURATION - Config file”.
>>
Work End.
PERFORM “MANUAL CONFIGURATION”
CONSULT
Select “MANUAL CONFIGURATION” to write Nissan Murano vehicle specifications into the around view monitor control unit.
CAUTION:
-
Thoroughly read and understand the Nissan Murano vehicle specification. Incorrect settings may result in abnormal control of ECU.
-
Make sure to select “NEXT” even if the default settings displayed on the CONSULT are the desired settings. If “NEXT” is not selected, the configuration process will be incomplete.
NOTE:
If manual configuration items are not displayed, touch “NEXT”.
>>
GO TO 4.
OPERATION CHECK
Confirm that each function controlled by around view monitor control unit operates normally.
>>
Work End.
Additional Service When Replacing Around View Monitor Control Unit
Description
BEFORE REPLACEMENTWhen replacing around view monitor control unit, save or print current vehicle specification with CONSULT configuration before replacement...
Predictive Course Line Center Position Adjustment
Description
Adjust the center position of the predictive course line of the rear view monitor if it is shifted.
Work Procedure
DRIVING
Drive the vehicle straight ahead 100 m (328...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Diagnosis and Repair Workflow
Work Flow OVERALL SEQUENCEDETAILED FLOWINTERVIEW CUSTOMER Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. REPRODUCE THE MALFUNCTION Reproduce the malfunction on the Nissan Murano vehicle that the customer describes...
Nissan Murano (Z52) 2015-2024 Service Manual: P0444 Evap Canister Purge Volume Control Solenoid Valve
DTC Description DTC DETECTION LOGIC An excessively low voltage signal is sent to ECM through the valve. An excessively high voltage signal is sent to ECM through the valve. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0444 PURG VOLUME CONT/V (Evaporative emission system purge control valve circuit open) Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from EVAP canister purge volume control solenoid valve to ECM Threshold An excessively low voltage signal is sent to ECM through the valve Diagnosis delay time — P0445 PURG VOLUME CONT/V (Evaporative emission system purge control valve circuit shorted) Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from EVAP canister purge volume control solenoid valve to ECM Threshold An excessively high voltage signal is sent to ECM through the valve Diagnosis delay time — POSSIBLE CAUSEDTC P0444 Harness or connectors (The solenoid valve circuit is open or shorted...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- System malfunction
- Warning lights
- All-Wheel Drive (AWD) (if so equipped)
- New on site
- Most important about car
