Nissan Murano: Warning lights, indicator lights and audible reminders / Checking lights

Nissan Murano (Z52) 2015-2024 Owners Manual / Instruments and controls / Warning lights, indicator lights and audible reminders / Checking lights

With all doors closed, apply the parking brake, fasten the seat belts and place the ignition switch in the ON position without starting the engine. The following lights (if so equipped) will come on:

Nissan Murano. Checking lights, Nissan Murano. Checking lights or Nissan Murano. Checking lights, Nissan Murano. Checking lights, Nissan Murano. Checking lights, Nissan Murano. Checking lights,

The following lights (if so equipped) come on briefly and then go off:

Nissan Murano. Checking lights or Nissan Murano. Checking lights, Nissan Murano. Checking lights, Nissan Murano. Checking lights, Nissan Murano. Checking lights,Nissan Murano. Checking lights

If any light fails to come on or operate in a way other than described, it may indicate a burned-out bulb and/or a system malfunction. Have the system checked. It is recommended that you visit a NISSAN dealer for this service.

Someindicators and warnings are also displayed in the vehicle information display between the speedometer and tachometer. For additional information, refer to “Vehicle information display” in this section.

    Warning lights, indicator lights and audible reminders

    ..

    Warning lights

    For additional information, refer to “Vehicle information display” in this section. Anti-lock Braking System (ABS) warning light or Whenthe ignition switch is placed in theON position, the ABS warning light illuminates and then turns off...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Door Motor Communication Circuit


    Diagnosis Procedure NOTE: If all of door motor DTCs are detected, check this circuit. CHECK EACH DOOR MOTOR COMMUNICATION SIGNAL Ignition switch ON. Check output waveform between A/C auto amp. harness connector and ground with the oscilloscope. + − Output waveform A/C auto amp...

    Nissan Murano (Z52) 2015-2024 Service Manual: Bcm


    Removal and Installation CAUTION: Before replacing the BCM, perform “READ CONFIGURATION” to save or print current Nissan Murano vehicle specification. Refer to Description. When replacing the BCM, a new BCM must be used. The functions controlled by the BCM do not operate properly if a BCM from another Nissan Murano vehicle is used...

    Categories

    Luggage hooks

    Nissan Murano. Luggage hooks

    When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs. (29 N) to a single hook.

    The luggage hooks that are located on the floor should have loads less than 110 lbs. (490 N) to a single hook.

    read more

     
    Copyright © 2026 www.nimurano.com