Nissan Murano: Rear Brake / Brake Pad

Nissan Murano (Z52) 2015-2024 Service Manual / Maintenance / Maintenance :: Periodic Maintenance / Chassis and Body Maintenance / Rear Brake / Brake Pad

Inspection

INSPECTION

Check brake pad wear thickness from an inspection hole (A) on cylinder body. Check using a scale if necessary.

Wear thickness : Refer to Rear Disc Brake.

    Rear Brake

    ..

    Disc Brake Rotor

    Inspection INSPECTIONAppearanceCheck surface of disc brake rotor for uneven wear, cracks or damage. Replace if any abnormal conditions exist.RunoutCheck the wheel bearing axial end play before the inspection...

    Other information:

    Nissan Murano (Z52) 2015-2024 Owners Manual: Intelligent Driver Alertness (I-DA) system limitations


    WARNING Listed below are the system limitations for the I–DA system. Failure to operate the vehicle in accordance with these system limitations could result in serious injury or death. The I-DA system may not operate properly and may not provide an alert in the following conditions: Poor road conditions such as an uneven road surface or pot holes...

    Nissan Murano (Z52) 2015-2024 Service Manual: B2738 Front Sensor Power


    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2738–11 FRONT SENSOR POWER (Front sensor power) — Diagnosis condition Ignition switch ON Signal (terminal) Front sensor power supply (terminal 11) Threshold Front sensor power supply is short to ground Diagnosis delay time 4 seconds or more B2738–12 Diagnosis condition Ignition switch ON Signal (terminal) Front sensor power supply (terminal 11) Threshold Front sensor power supply is short to voltage Diagnosis delay time 4 seconds or more B2738–87 Diagnosis condition Ignition switch ON Signal (terminal) Front sensor power supply (terminal 11) Threshold Connection error is detected between sonar control unit and Front sonar sensors Diagnosis delay time 4 seconds or more POSSIBLE CAUSE Harness or connectors Sonar control unit FAIL-SAFEObstacle detection function is deactivated DTC Confirmation Procedure DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...

    Categories

    Fuel gauge

    Nissan Murano. Fuel gauge

    The gauge indicates the approximate fuel level in the tank.

    The gauge may move slightly during braking, turning, acceleration, or going up or down hills.

    The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.

    read more

     
    Copyright © 2026 www.nimurano.com