Nissan Murano: Brake System :: Basic Inspection / Brake Master Cylinder
Nissan Murano (Z52) 2015-2024 Service Manual / Brakes / Brake System :: Basic Inspection / Brake Master Cylinder
Check for brake fluid leakage at the following areas:
-
Master cylinder mounting face
-
Reservoir tank mounting face
-
Sub tank mounting face
-
Brake tube and brake tube connections
-
Brake hose and brake hose connections
If any brake fluid leakage is found, repair as necessary.
Brake Fluid
Inspection
BRAKE FLUID LEVEL
Make sure that the brake fluid level in the sub tank is between the MAX and MIN lines.
Visually check around the sub tank and reservoir tank for brake fluid leakage...
Brake Booster
Inspection
VACUUM INSPECTIONIdle the engine for one minute to apply vacuum to the brake booster. Stop the engine. Depress the brake pedal several times at five second intervals until the accumulated vacuum is released to atmospheric pressure...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: U1304 Camera Image Calibration
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1304 CAMERA IMAGE CALIB (Camera image calibration) Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold — Diagnosis delay time — POSSIBLE CAUSECamera calibration is incomplete...
Nissan Murano (Z52) 2015-2024 Service Manual: Preparation. Preparation
..
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Turning the AEB system on/off
- Vehicle Dynamic Control (VDC) OFF switch
- Checking engine oil level
- New on site
- Most important about car
Fuel gauge
The gauge indicates the approximate fuel level in the tank.
The gauge may move slightly during braking, turning, acceleration, or going up or down hills.
The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.
Copyright © 2026 www.nimurano.com