Nissan Murano: Road Wheels & Tires :: Basic Inspection / Configuration (tire Pressure Monitoring System)

Nissan Murano (Z52) 2015-2024 Service Manual / Suspension / Road Wheels & Tires :: Basic Inspection / Configuration (tire Pressure Monitoring System)

Work Procedure

NOTE:

  • Use “Manual Configuration”.

  • If an error occurs during configuration, start over from the beginning.

CHECK DATA PART NO. (TYPE ID)

  1. Use FAST (service parts catalog) to search TPMS “DATA PART NO. (TYPE ID)”.

  2. Write down “DATA PART NO. (TYPE ID)”.

>>

GO TO 2.

WRITE CONFIGURATION

CONSULT Configuration

  1. Select “Manual Configuration” of “AIR PRESSURE MONITOR”.

  2. Select the “DATA PART NO. (TYPE ID)” found using FAST (service parts catalog) to write the “DATA PART NO. (TYPE ID)” into the BCM.

>>

GO TO 3.

VERIFY DATA PART NO. (TYPE ID)

Compare the “DATA PART NO. (TYPE ID)” written into the BCM with the one found using FAST (service parts catalog) to confirm they match.

Do DATA PART NOs match?

YES>>

GO TO 4.

NO>>

GO TO 2.

PERFORM TIRE PRESSURE SENSOR ID REGISTRATION

Perform tire pressure sensor ID registration. Refer to Work Procedure.

>>

GO TO 5.

PERFORM SUPPLEMENTARY WORK

  1. Adjust the tire pressures for all tires to the recommended value. Refer to Tire Air Pressure.

  2. Perform self-diagnosis of all systems.

  3. Erase self-diagnosis results.

>>

Work End.

    Id Registration Procedure

    Description This procedure must be performed after replacement of a tire pressure sensor or BCM. Work Procedure TPMS ID registration can be performed using one of the following procedures: Transmitter Activation tool [KV48105501 (J-45295-A)] using CONSULT (preferred method) Signal Tech II tool [– (J-50190)] with CONSULT (preferred method) Signal Tech II tool [– (J-50190)] without CONSULT CONSULT only TPMS REGISTRATION WITH TRANSMITTER ACTIVATION TOOL [KV48105501 (J-45295-A)]CONSULT Ignition switch ON...

    Road Wheels & Tires :: Dtc/circuit Diagnosis

    ..

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Door Outside Molding


    Exploded View 1. Front door panel 2. Front door outside molding 3. Rear door panel 4. Rear door outside molding Pawl Removal and Installation FRONT DOOR OUTSIDE MOLDINGRemovalLower front door glass. Remove door mirror. Refer to Removal and Installation...

    Nissan Murano (Z52) 2015-2024 Service Manual: Body Sealing


    Description The following figure shows the areas which are sealed at the factory. Sealant which has been applied to these areas should be smooth and free from cuts or gaps. Care should be taken not to apply an excess amount of sealant and not to allow other unaffected parts to come into contact with the sealant...

    Categories

    Driver and passenger supplemental knee air bag

    Nissan Murano. Driver and passenger supplemental knee air bag

    Driver’s side

    The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.

    Nissan Murano. Driver and passenger supplemental knee air bag

    Passenger’s side

    read more

     
    Copyright © 2026 www.nimurano.com