Nissan Murano: Do-it-yourself / Battery

- If the battery is labeled “do not open” it is maintenance free and
battery fluid should not be checked. It is recommended that you visit
a NISSAN dealer or a qualified specialist workshop to confirm the battery’s
performance.
- Keep the battery surface clean and dry. Clean the battery with a
solution of baking soda and water.
- Make certain the terminal connections are clean and securely tightened.
- If the vehicle is not to be used for 30 days or longer, disconnect the
negative (-) battery terminal cable to prevent discharge.
NOTE:
Care should be taken to avoid situations
that can lead to potential battery dischargeandpotential
no-start conditions
such as:
- Installation or extended use of electronic
accessories that consume battery
power when the engine is not
running (Phone chargers, GPS, DVD
players, etc.)
- Vehicle is not driven regularly and/or
only driven short distances.
In these cases, the battery may need to
be charged to maintain battery health.
WARNING
- Do not expose the battery to flames,
an electrical spark or a cigarette. Hydrogen
gas generated by the battery
is explosive. Explosive gases can
cause blindness or injury.Do not allow
battery fluid to contact your skin,
eyes, fabrics or painted surfaces. Sulfuric
acid can cause blindness or injury.
After touching a battery or battery
cap, do not touch or rub your
eyes. Thoroughly wash your hands. If
the acid contacts your eyes, skin or
clothing, immediately flush with water
for at least 15 minutes and seek
medical attention.
- When working on or near a battery,
always wear suitable eye protection
and remove all jewelry.
- Battery posts, terminals and related
accessories contain lead and lead
compounds. Wash hands after
handling.
- Keep battery out of the reach of
children.
- Do not tip the battery.

NOTE:
Do not try to open the top of the battery.
This battery is not equipped with removable
vent caps.
JUMP STARTING
If jump starting is necessary, refer to “Jump
starting” in the “In case of emergency” section
of this manual. If the engine does not
start by jump starting, the battery may
have to be replaced. It is recommended
that you visit a NISSAN dealer for this service.
Fill the windshield-washer fluid reservoir periodically.
Add windshield-washer fluid when
the “Low Washer Fluid” warning message
shows on the vehicle information display...
VQ35DE engine
Crankshaft pulley
Drive belt automatic tensioner pulley
Generator pulley
Air conditioner compressor pulley
WARNING
Be sure the ignition switch is placed in
the OFF or LOCK position before servicing
drive belt...
Other information:
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC detection condition
C1A03-29
VHCL SPEED SE CIRC
(Nissan Murano Vehicle speed sensor circuit)
Diagnosis condition
When engine is running
When MAIN switch of ICC system is ON
Signal (terminal)
—
Threshold
If the Nissan Murano vehicle speed signal (wheel speed) from ABS actuator and electric unit (control unit) and the CVT vehicle speed sensor signal (output shaft revolution signal) from TCM, received by the ADAS control unit via CAN communication, are inconsistent
Diagnosis delay time
1 second or less
POSSIBLE CAUSE
Wheel speed sensor
ABS actuator and electric unit (control unit)
Nissan Murano Vehicle speed sensor CVT (output speed sensor)
TCM
ADAS control unit
FAIL-SAFEThe following systems are canceled:
Vehicle-to-vehicle distance control mode
Automatic Emergency Braking (AEB) with pedestrian detection
Automatic Emergency Braking (AEB)
Intelligent Forward Collision Warning (I-FCW)
Lane Departure Warning (LDW)
Intelligent Lane Intervention (I-LI)
Blind Spot Warning (BSW)
Rear Cross Traffic Alert (RCTA)
Rear Automatic Braking (RAB)
Confirmation Procedure
CHECK DTC PRIORITY
If DTC “C1A03–29” is displayed with DTC “U1000–01” or “C1A04–97”, first diagnose the DTC “U1000–01” or “C1A04–97”...
The climate controlled seat warms up or
cools down the front seat by blowingwarm
or cool air from under the surface of the
seat. The climate control switch is located
on the center console.
The climate controlled seat can be operated
as follows:
Place the ignition switch in the ON position...