Nissan Murano: Back Door / Back Door Weather-Strip
REMOVAL
Carefully remove back door weather-strip from opening door joint.
INSTALLATION
NOTE:
Pull weather-strip gently to ensure that there are no loose sections.
Beginning with upper section, align weather-strip mark with vehicle center position mark and install weather-strip to Nissan Murano vehicle.
For lower section, align weather-strip seam with center of back door striker.
NOTE:
Pull weather-strip gently to ensure that there are no loose sections.
Back Door Hinge
Removal and Installation
REMOVALRemove back door assembly. Refer to Removal and Installation.
Partially remove rear of headlining. Refer to Removal and Installation...
Hood Lock
..
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Performance Test
Inspection INSPECTION PROCEDURE Connect recovery/recycling/recharging equipment (for HFO-1234yf) or manifold gauge. Start the engine, and set to the following conditions. Test condition Surrounding condition Indoors or in the shade (in a well-ventilated place) Nissan Murano Vehicle condition Door Closed Door glass Full open Hood Open Engine speed Idle speed A/C condition Temperature control switch or dial Full cold A/C switch ON Air outlet VENT (ventilation) Intake door position Recirculation Fan (blower) speed Maximum speed set Maintain test condition until A/C system becomes stable (approximately 10 minutes)...
Nissan Murano (Z52) 2015-2024 Service Manual: Main Power Window and Door Lock/unlock Switch
Removal and Installation REMOVAL Pull armrest in direction shown () then starting at rear release main power window and door lock/unlock switch finisher (1) pawls using a suitable tool (A). : Front : Pawl Disconnect the harness connectors (A) from the main power window and door lock/unlock switch (1) and harness connector (B) from the door mirror remote control switch (2) and remove...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- All-Wheel Drive (AWD) (if so equipped)
- Settings
- Turning the AEB system on/off
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
