Nissan Murano: Back Door / Back Door Hinge
Removal and Installation
REMOVAL
Remove back door assembly. Refer to Removal and Installation.
Partially remove rear of headlining. Refer to Removal and Installation.
Remove nuts and back door hinge.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
Tighten nuts to specification. Refer to Exploded View.
-
Apply anticorrosive agent onto surface between hinge and body side.
-
After installation, perform back door assembly adjustment procedure. Refer to Adjustment.
Removal and Installation
REMOVALRemove back door kicking plate. Refer to Removal and Installation.
Remove bolts and back door striker.INSTALLATIONInstallation is in the reverse order of removal...
Removal and Installation
REMOVALCarefully remove back door weather-strip from opening door joint.INSTALLATIONNOTE:
Pull weather-strip gently to ensure that there are no loose sections...
Other information:
DTC Description
DTC DETECTION LOGIC
Rationally incorrect voltage from the sensor is sent to ECM, compared with the voltage signals from EOT sensor and intake air temperature sensor.
The comparison result of signals transmitted to ECM from each temperature sensor (IAT sensor, ECT sensor, FTT sensor, and EOT sensor) shows that the signal voltage of the EOT sensor is higher/lower than that of other temperature sensors when the engine is started with its cold state...
Towing your vehicle with all four wheels on
the ground is sometimes called flat towing.
This method is sometimes used when
towing a vehicle behind a recreational vehicle,
such as a motor home.
CAUTION
Failure to follow these guidelines can
result in severe transmission damage...