Nissan Murano: Dtc/circuit Diagnosis / B2562 Low Voltage

Nissan Murano (Z52) 2015-2024 Service Manual / Electrical & Power Control / Body Control System :: Bcm / Dtc/circuit Diagnosis / B2562 Low Voltage

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition
B2562

LOW VOLTAGE

(Low voltage)
Diagnosis condition When ignition switch ON.
Signal (terminal) BCM power circuit (terminal 139 and 131 and ground)
Threshold Less than 8.8V
Diagnosis delay time 120 seconds or more

POSSIBLE CAUSE

  • Harness or connector (power supply circuit)

  • BCM

FAIL-SAFE

Inhibit cranking

DTC CONFIRMATION PROCEDURE

DTC CONFIRMATION PROCEDURE

CONSULT

  1. Erase DTC.

  2. Ignition switch OFF.

  3. Select the “Self Diagnostic Result” mode of “BCM”, after ignition switch ON for 120 seconds or more.

Is any DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK POWER SUPPLY CIRCUIT

Check BCM power supply circuit. Refer to Diagnosis Procedure.

Is the circuit normal?

YES>>

Replace BCM. Refer to Removal and Installation.

NO>>

Repair the malfunctioning part.

    U0415 Vehicle Speed

    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition U0415 Nissan Murano Vehicle SPEED (Vehicle speed signal) Diagnosis condition When ignition switch ON...

    B259a Room Lamp Fuse Blown

    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition B259A ROOM LAMP FUSE BLOWN (Room lamp fuse blown) Diagnosis condition When ignition switch ON...

    Other information:

    Nissan Murano (Z52) 2015-2024 Owners Manual: Flat towing for front wheel drive vehicle (if so equipped)


    Towing your vehicle with all four wheels on the ground is sometimes called flat towing. This method is sometimes used when towing a vehicle behind a recreational vehicle, such as a motor home. CAUTION Failure to follow these guidelines can result in severe transmission damage...

    Nissan Murano (Z52) 2015-2024 Service Manual: Engine Control System Symptoms


    Symptom Table SYSTEM — BASIC ENGINE CONTROL SYSTEM  SYMPTOM Reference page HARD/NO START/RESTART (EXCP. HA) ENGINE STALL HESITATION/SURGING/FLAT SPOT SPARK KNOCK/DETONATION LACK OF POWER/POOR ACCELERATION HIGH IDLE/LOW IDLE ROUGH IDLE/HUNTING IDLING VIBRATION SLOW/NO RETURN TO IDLE OVERHEATS/WATER TEMPERATURE HIGH EXCESSIVE FUEL CONSUMPTION EXCESSIVE OIL CONSUMPTION BATTERY DEAD (UNDER CHARGE) Warranty symptom code AA AB AC AD AE AF AG AH AJ AK AL AM HA Fuel Fuel pump circuit 1 1 2 3 2   2 2     3   2 Diagnosis Procedure Fuel pressure regulator system 3 3 4 4 4 4 4 4 4   4     Work Procedure Fuel injector circuit 1 1 2 3 2   2 2     2     Component Function Check Evaporative emission system 3 3 4 4 4 4 4 4 4   4     System Description Air Positive crankcase ventilation system 3 3 4 4 4 4 4 4 4   4 1   Positive Crankcase Ventilation (PCV) Incorrect idle speed adjustment       1 1 1 1   1     Work Procedure Electric throttle control actuator 1 1 2 3 3 2 2 2 2   2   2 DTC Description, DTC Description Ignition Incorrect ignition timing adjustment 3 3 1 1 1   1 1     1     Work Procedure Ignition circuit 1 1 2 2 2   2 2     2     Component Function Check Power supply and ground circuit 2 2 3 3 3   3 3   2 3   Diagnosis Procedure Mass air flow sensor circuit 1 1 2 2 2   2 2     2     DTC Description, DTC Description Engine coolant temperature sensor circuit 3 3 3       DTC Description, DTC Description Air fuel ratio (A/F) sensor 1 circuit             DTC Description, DTC Description, DTC Description, DTC Description, DTC Description Throttle position sensor circuit     2 2       DTC Description, DTC Description, DTC Description, DTC Description, DTC Description Accelerator pedal position sensor circuit     3 2 1             DTC Description, DTC Description, DTC Description, DTC Description Knock sensor circuit     2               3     DTC Description Engine oil temperature sensor 4 2       3     DTC Description, DTC Description Crankshaft position sensor (POS) circuit 2 2           DTC Description Camshaft position sensor (PHASE) circuit 3 2           DTC Description Nissan Murano Vehicle speed signal circuit   2 3   3           3     DTC Description ECM 2 2 3 3 3 3 3 3 3 3 3     DTC Description, DTC Description Intake valve timing control solenoid valve circuit   3 2   1 3 2 2 3   3     DTC Description Intake valve timing intermediate lock control solenoid valve circuit DTC Description Exhaust valve timing control solenoid valve 3 2   1 3 2 2 3   3 DTC Description PNP signal circuit     3   3   3 3     3     DTC Description VIAS control solenoid valve 1 circuit 1 DTC Description VIAS control solenoid valve 2 circuit 1 DTC Description Refrigerant pressure sensor circuit   2   3 3   4     Component Function Check Electrical load signal circuit             3           Component Function Check Air conditioner circuit 2 2 3 3 3 3 3 3 3   3   2 Work Flow ABS actuator and electric unit (control unit) 4 Work Flow 1 - 6: The numbers refer to the order of inspection...

    Categories

    Unfastening the seat belts. Checking seat belt operation

    Unfastening the seat belts

    Nissan Murano. Unfastening the seat belts. Checking seat belt operation

    To unfasten the seat belt, press the button on the buckle Nissan Murano. Unfastening the seat belts. Checking seat belt operation. The seat belt automatically retracts.

    read more

     
    Copyright © 2026 www.nimurano.com