Nissan Murano: Dtc/circuit Diagnosis / U0415 Vehicle Speed
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| U0415 |
Nissan Murano Vehicle SPEED (Vehicle speed signal) |
Diagnosis condition | When ignition switch ON. |
| Signal (terminal) | — | ||
| Threshold | — | ||
| Diagnosis delay time | 2 seconds or more | ||
POSSIBLE CAUSE
-
ABS actuator and electric unit (control unit)
-
BCM
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CONSULT
-
Erase the DTC.
-
Ignition switch OFF.
-
Select “Self Diagnostic Result” mode of “BCM”, after ignition switch ON for 2 seconds or more.
Is any DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
SELF DIAGNOSTIC RESULT
CONSULT
-
Ignition switch ON.
-
Select “Self Diagnostic Result” mode of “ABS”.
-
Check DTC.
Is any DTC detected?
YES>>Repair or replace the malfunctioning part.
NO>>Replace BCM. Refer to Removal and Installation.
U1010 Control Unit(can)
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition
U1010
CONTROL UNIT(CAN)
[Control unit (CAN)]
Diagnosis condition
When ignition switch ON...
B2562 Low Voltage
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition
B2562
LOW VOLTAGE
(Low voltage)
Diagnosis condition
When ignition switch ON...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Moonroof Does Not Operate Properly
Diagnosis Procedure CHECK BCM POWER SUPPLY AND GROUND CIRCUIT Check BCM power supply and ground circuit. Refer to Diagnosis Procedure. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace malfunctioning parts. CHECK MOONROOF MOTOR ASSEMBLY POWER SUPPLY AND GROUND CIRCUIT Check moonroof motor assembly power supply and ground circuit...
Nissan Murano (Z52) 2015-2024 Service Manual: How to Read Wiring Diagrams
Connector Symbols Most connector symbols in wiring diagrams are shown from the terminal side. Connector symbols shown from the terminal side are enclosed by a single line and followed by the direction mark. Connector symbols shown from the harness side are enclosed by a double line and followed by the direction mark...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Intelligent Forward Collision Warning (I-FCW)
- Fuel recommendation
- Rear bench seat adjustment
- New on site
- Most important about car
Seatback pockets
Theremaybe one or two seatback pockets located on the back of the driver and passenger seats. The pockets can be used to store maps.
WARNING
