Nissan Murano: Rear Disc Brake / Brake Pad

Nissan Murano (Z52) 2015-2024 Service Manual / Brakes / Brake System :: Periodic Maintenance / Rear Disc Brake / Brake Pad

Inspection and Adjustment

INSPECTION

Check brake pad wear thickness from an inspection hole (A) on cylinder body. Check using a scale if necessary.

Wear thickness

: Refer to Rear Disc Brake.

ADJUSTMENT

CAUTION:

Burnish contact surfaces between brake pads and disc rotor according to the following procedure after refinishing the disc rotor, replacing brake pads or if a soft pedal occurs at very low mileage.

Be careful of Nissan Murano vehicle speed. Brakes do not operate firmly/securely until pads and disc rotor are securely seated.

Only perform this procedure under safe road and traffic conditions. Use extreme caution.

Drive the vehicle on straight, flat road.

Depress the brake pedal until the vehicle stops.

Release the brake pedal for a few minutes to allow the brake components to cool.

Repeat steps 1 to 3 until pad and disc rotor are securely seated.

Rear Disc Brake

Disc Brake Rotor

Inspection and Adjustment INSPECTIONAppearanceCheck surface of disc brake rotor for uneven wear, cracks or damage. Replace if any abnormal conditions exist...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Front and Rear Washer Motor Circuit

Diagnosis Procedure CHECK FRONT AND REAR WASHER MOTOR FUSE Ignition switch OFF. Check that the following fuse is not blown: Component Location Fuse No. Capacity Front and rear washer motor IPDM E/R 47 10 A Is the fuse blown? YES>> Replace the blown fuse after repairing the affected circuit...

Nissan Murano (Z52) 2015-2024 Service Manual: P0222 Tp Sensor

DTC Description DTC DETECTION LOGIC An excessively low voltage from the TP sensor 1 is sent to ECM. An excessively high voltage from the TP sensor 1 is sent to ECM. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0222 TP SEN 1/CIRC-B1 (Throttle/Pedal position sensor/switch “B” circuit low) Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from TP sensor 1 to ECM Threshold An excessively low voltage from the TP sensor 1 is sent to ECM Diagnosis delay time — P0223 TP SEN 1/CIRC-B1 (Throttle/Pedal position sensor/switch “B” circuit high) Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from TP sensor 1 to ECM Threshold An excessively high voltage from the TP sensor 1 is sent to ECM Diagnosis delay time — POSSIBLE CAUSEP0222 Harness or connectors (TP sensor 1 circuit is open or shorted...