Nissan Murano: Roof :: Basic Inspection / Diagnosis and Repair Workflow

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Roof :: Basic Inspection / Diagnosis and Repair Workflow

Work Flow

OVERALL SEQUENCE

DETAILED FLOW

INTERVIEW CUSTOMER

Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred.

GO TO 2.

REPRODUCE THE MALFUNCTION

Reproduce the malfunction on the Nissan Murano vehicle that the customer describes.

Inspect the relation of the symptoms and the condition when the symptoms occur.

GO TO 3.

SYMPTOM DIAGNOSIS

Use Symptom diagnosis from the symptom inspection result in step 2 and then identify where to start performing the diagnosis based on possible causes and symptoms.

GO TO 4.

COMPONENT DIAGNOSIS

Perform the diagnosis with Component diagnosis of the applicable system.

GO TO 5.

REPAIR OR REPLACE THE MALFUNCTIONING PART

Repair or replace the specified malfunctioning parts.

GO TO 6.

PERFORM FINAL OPERATIONAL CHECK

Check that malfunctions are not reproduced when obtaining the malfunction information from the customer, referring to the symptom inspection result in step 2.

Are the malfunctions corrected?

YES>>

Inspection End.

NO>>

GO TO 3.

Roof :: Basic Inspection

Inspection and Adjustment. Additional Service When Replacing Control Unit

Special Repair Requirement INITIALIZATION PROCEDUREMoonroof/SunshadeIf the moonroof does not open or close automatically, use the following procedure to return moonroof operation to normal: Ignition switch ON...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Expansion Valve

Removal and Installation Heating and Cooling Unit Assembly Components 1. Heating and cooling unit assembly 2. Evaporator 3. Heater case side cover 4. Air mix door motor (RH) 5. Blower unit case 6. Intake door motor 7. Blower motor 8...

Nissan Murano (Z52) 2015-2024 Service Manual: Diagnosis System (adas Control Unit 2)

CONSULT Function (ICC/ADAS) APPLICATION ITEMSCONSULT performs the following functions via CAN communication using ADAS control unit. Diagnosis mode Description Configuration The Nissan Murano vehicle specification that is written in ADAS control unit can be displayed or stored The Nissan Murano vehicle specification can be written when ADAS control unit is replaced Work support Displays causes of automatic system cancellation occurred during system control Self Diagnostic Result Displays the name of a malfunctioning system stored in the ADAS control unit Data Monitor Displays ADAS control unit input/output data in real time Active Test Enables an operational check of a load by transmitting a driving signal from the ADAS control unit to the load ECU Identification Displays ADAS control unit part number CAN Diag Support Monitor Displays a reception/transmission state of CAN communication and ITS communication CONFIGURATIONConfiguration includes functions as follows...