Nissan Murano: Three-point type seat belt with retractor / Attaching the center seat belt
Always be sure the center seat belt connector tongue and connector buckle are attached. Disconnect only when folding down the rear seat.
To connect the buckle:
- Pull out the connector tongue from the
retractor base
.
- Pull out the seat belt tongue from the
retractor base
.
- Pull the seat belt and secure the connector
buckle until it clicks
.
The center seat belt connector tongue can be attached only into the rear center seat belt connector buckle.
To fasten the seat belt, refer to "Fastening the seat belts" in this section.
WARNING
- Do not unfasten the rear center seat belt connector except when folding down the rear seat.
- When attaching the rear center seat belt connector, be certain that the seatbacks are completely secured in the latched position and the rear center seat belt connector is completely secured.
- If the rear center seat belt connector and the seatbacks are not secured in the correct position, serious personal injury may result in an accident or sudden stop.
Rear center seat belt
The rear center seat belt has a connector
tongue and a seat belt tongue
. Both
the connector tongue and the seat belt
tongue must be securely latched for
proper seat belt operation...
Shoulder belt height adjustment (front seats)
The shoulder belt anchor height should be
adjusted to the position best for you. For
additional information, refer to “Precautions
on seat belt usage” in this section...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Tcu
Removal and Installation REMOVALCAUTION: Before replacing TCU, perform “ADDITIONAL SERVICE WHEN REPLACING TCU”. For details, refer to Description. Remove the cluster lid D. Refer to Removal and Installation. Remove the A/C switch assembly. Refer to Removal and Installation...
Nissan Murano (Z52) 2015-2024 Service Manual: Drive Pinion
Exploded View Oil seal Transfer cover Filler plug Gasket Drain plug Oil seal O-ring Ring gear bearing adjusting shim (transfer cover side) Ring gear bearing (transfer cover side) Drive shaft oil seal Ring gear shaft Ring gear bearing (transfer case side) Ring gear bearing adjusting shim (transfer case side) Ring gear Baffle plate Transfer case Plug O-ring Oil seal Dowel pin Drive pinion Drive pinion adjusting shim O-ring Pinion bearing assembly Oil seal Dust cover Companion flange Pinion lock nut Oil seal lip Comply with the assembly procedure when tightening...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Tire rotation
- Shift lock release
- Jacking up vehicle and removing the damaged tire
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
