Nissan Murano: Safety—Seats, seat belts and supplemental restraint system / Seat belts

Nissan Murano (Z52) 2015-2024 Owners Manual / Safety—Seats, seat belts and supplemental restraint system / Seat belts

Adjust

For adjustable head restraint/headrest Adjust the head restraint/headrest so the center is level with the center of your ears. If your ear position is still higher than the recommended alignment, place the head restraint/headrest at the highest position...

Precautions on seat belt usage

If you are wearing your seat belt properly adjusted and you are sitting upright and well back in your seat with both feet on the floor, your chances of being injured or killed in a collision and/or the severity of injury may be greatly reduced...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: C1a03-29 Vhcl Speed Se Circ


DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition   C1A03-29 VHCL SPEED SE CIRC (Nissan Murano Vehicle speed sensor circuit) Diagnosis condition When engine is running When MAIN switch of ICC system is ON Signal (terminal) — Threshold If the Nissan Murano vehicle speed signal (wheel speed) from ABS actuator and electric unit (control unit) and the CVT vehicle speed sensor signal (output shaft revolution signal) from TCM, received by the ADAS control unit via CAN communication, are inconsistent Diagnosis delay time 1 second or less POSSIBLE CAUSE Wheel speed sensor ABS actuator and electric unit (control unit) Nissan Murano Vehicle speed sensor CVT (output speed sensor) TCM ADAS control unit FAIL-SAFEThe following systems are canceled: Vehicle-to-vehicle distance control mode Automatic Emergency Braking (AEB) with pedestrian detection Automatic Emergency Braking (AEB) Intelligent Forward Collision Warning (I-FCW) Lane Departure Warning (LDW) Intelligent Lane Intervention (I-LI) Blind Spot Warning (BSW) Rear Cross Traffic Alert (RCTA) Rear Automatic Braking (RAB) Confirmation Procedure CHECK DTC PRIORITY If DTC “C1A03–29” is displayed with DTC “U1000–01” or “C1A04–97”, first diagnose the DTC “U1000–01” or “C1A04–97”...

Nissan Murano (Z52) 2015-2024 Service Manual: Av Control Unit


Exploded View 1. AV control unit bracket (RH) 2. AV control unit 3. AV control unit bracket (LH) 4. A/C auto amp. Removal and Installation REMOVALCAUTION: Before disconnecting the AV control unit and battery terminals, turn the ignition switch OFF and wait at least 30 seconds...

Categories

LATCH (Lower Anchors and Tethers for CHildren) system

Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

LATCH system lower anchor locations - bench seat

Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.

read more

 
Copyright © 2026 www.nimurano.com