Nissan Murano: Three-point type seat belt with retractor / Shoulder belt height adjustment (front seats)
The shoulder belt anchor height should be
adjusted to the position best for you. For
additional information, refer to “Precautions
on seat belt usage” in this section. To
adjust, pull out the adjustment button
and move the shoulder belt anchor to the
desired position 
, so the belt passes over
the center of the shoulder. The belt should
be away from your face and neck, but not
falling off your shoulder. Release the adjustment
button to lock the shoulder belt
anchor into position.
WARNING
- After adjustment, release the adjustment button and try to move the shoulder belt anchor up and down to make sure it is securely fixed in position.
- The shoulder belt anchor height should be adjusted to the position best for you. Failure to do so may reduce the effectiveness of the entire restraint system and increase the chance or severity of injury in an accident.
Seat belt hook
When the seat belt is not in use and when folding down the rear seats, hook the rear seat belts on the seat belt hooks.
Attaching the center seat belt
Always be sure the center seat belt connector
tongue and connector buckle are
attached. Disconnect only when folding
down the rear seat.
To connect the buckle:
Pull out the connector tongue from the
retractor base ...
Seat belt extenders
If, because of body size or driving position, it
is not possible to properly fit the
lap/shoulder belt and fasten it, an extender
that is compatible with the installed seat
belts is available for purchase...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P0182 Ftt Sensor
DTC Description DTC DETECTION LOGIC An excessively low voltage from the sensor is sent to ECM. An excessively high voltage from the sensor is sent to ECM. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0182 FTT_SEN/CIRCUIT (Fuel temperature sensor “A” circuit low) Diagnosis condition Ignition switch ON Signal (terminal) Voltage signal transmitted from fuel tank temperature sensor to ECM Threshold An excessively low voltage from the sensor is sent to ECM Diagnosis delay time — P0183 FTT_SEN/CIRCUIT (Fuel temperature sensor “A” circuit high) Diagnosis condition Ignition switch ON Signal (terminal) Voltage signal transmitted from fuel tank temperature sensor to ECM Threshold An excessively high voltage from the sensor is sent to ECM Diagnosis delay time — POSSIBLE CAUSEP0182 Harness or connectors (The sensor circuit is open or shorted...
Nissan Murano (Z52) 2015-2024 Service Manual: Precaution. Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- How to enable/disable the LDW system
- Fuel recommendation
- Turning the AEB system on/off
- New on site
- Most important about car
Vehicle security system
Your vehicle has two types of security systems:
Vehicle security system NISSAN Vehicle Immobilizer SystemThe vehicle security system provides visual and audible alarm signals if someone opens the doors, liftgate or the hood when the system is armed. It is not, however, a motion detection type system that activates when a vehicle is moved or when a vibration occurs.
