Nissan Murano: Basic Inspection / Additional Service When Replacing Sonar Control Unit

Description

BEFORE REPLACEMENT

When replacing sonar control unit, save or print current vehicle specification with CONSULT configuration before replacement.

NOTE:

If “Before Replace ECU” cannot be used, use the “After Replace ECU” or “Manual Configuration” after replacing sonar control unit.

AFTER REPLACEMENT

CAUTION:

When replacing sonar control unit, you must perform “After Replace ECU” with CONSULT.

SAVING VEHICLE SPECIFICATION

CONSULT

Enter “Re/Programming, Configuration” and perform “Before Replace ECU” to save or print current Nissan Murano vehicle specification.

NOTE:

If “Before Replace ECU” cannot be used, use the “After Replace ECU” or “Manual Configuration” after replacing sonar control unit.

GO TO 2.

REPLACE SONAR CONTROL UNIT

Replace sonar control unit. Refer to Removal and Installation.

GO TO 3.

WRITING Nissan Murano Vehicle SPECIFICATION

CONSULT

1. Enter "Re/Programming, Configuration".

2. If “Before Replace ECU” operation was performed, an "Operation Log Selection" screen will automatically be displayed. Select the applicable file from the "Saved Data List" and press “Confirm” to write Nissan Murano vehicle specification. Refer to Work Procedure.

3. If “Before Replace ECU” operation was not performed, select "After Replace ECU" or "Manual Configuration" to write Nissan Murano vehicle specification. Refer to Work Procedure.

GO TO 4.

OPERATION CHECK

Check that the operation of the sonar control unit is normal.

Work End.