Nissan Murano: Driver Controls / Wiper & Washer :: Symptom Diagnosis

Rear Wiper Motor Circuit

Component Function Check CHECK REAR WIPER ON OPERATION CONSULT Select “RR WIPER” in “Active Test” mode of “BCM(WIPER)”. While operating the test item, check rear wiper operation...

Wiper and Washer System Symptoms

Symptom Table CAUTION: Perform the “Self Diagnostic Result” with Consult before performing the diagnosis by symptom. Perform the diagnosis by DTC if DTC is detected...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: The Light Reminder Warning Does Not Sound

Diagnosis Procedure Light reminder warning does not sound even though headlamp is illuminated.CHECK COMBINATION SWITCH (LIGHTING SWITCH) OPERATION Check that the headlamps operate normally by operating the combination switch (lighting switch). Do they operate normally? YES>> GO TO 2...

Nissan Murano (Z52) 2015-2024 Service Manual: P0127 Iat Sensor

DTC Description DTC DETECTION LOGICRationally incorrect voltage from the sensor is sent to ECM, compared with the voltage signal from engine coolant temperature sensor. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0127 IAT SENSOR-B1 (Intake air temperature too high) Diagnosis condition — Signal (terminal) Voltage signal transmitted from intake air temperature sensor to ECM Threshold Rationally incorrect voltage from the sensor is sent to ECM, compared with the voltage signal from engine coolant temperature sensor Diagnosis delay time — POSSIBLE CAUSE Harness and connectors (The sensor circuit is open or shorted) Intake air temperature sensor FAIL-SAFENot applicable DTC Confirmation Procedure PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test...