Nissan Murano: Changing engine oil and oil filter / Vehicle set-up

Nissan Murano (Z52) 2015-2024 Owners Manual / Do-it-yourself / Engine oil / Changing engine oil and oil filter / Vehicle set-up

Park the vehicle on a level surface and apply the parking brake.
Run the engine until it reaches operating temperature.
Turn the engine off and wait for 15 minutes.
Raise and support the vehicle using a suitable floor jack and safety jack stands.
- Place the safety jack stands under the vehicle jack-up points.
- A suitable adapter should be attached to the jack stand saddle.

CAUTION

Make sure the correct lifting and support points are used to avoid vehicle damage.

Changing engine oil and oil filter

F..

Removal of engine protectors

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: B260f Eng State Sig Lost

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition B260F ENG STATE SIG LOST (Engine state signal lost) Diagnosis condition When ignition switch is ON. Signal (terminal) — Threshold BCM has not yet received the engine status signal from ECM when ignition switch is in the ON position...

Nissan Murano (Z52) 2015-2024 Owners Manual: Hood

Pull the hood lock release handle located below the driver side instrument panel until the hood springs up slightly. Locate the lever in between the hood and grille and push the lever sideways with your fingertips and raise the hood ...