Nissan Murano: Changing engine oil and oil filter / Removal of engine protectors

Vehicle set-up

Park the vehicle on a level surface and apply the parking brake. Run the engine until it reaches operating temperature. Turn the engine off and wait for 15 minutes...

Engine oil and filter

Place a large drain pan under the drain plug and oil filter. Remove the oil filler cap. Remove the drain plug with a wrench by turning it counterclockwise and completely drain the oil...

Other information:

Nissan Murano (Z52) 2015-2024 Owners Manual: Doors

When the doors are locked using one of the following methods, the doors cannot be opened using the inside or outside door handles. The doors must be unlocked to open the doors. WARNING Always have the doors locked while driving. Along with the use of seat belts, this provides greater safety in the event of an accident by helping to prevent persons from being thrown from the vehicle...

Nissan Murano (Z52) 2015-2024 Service Manual: U0102 Lost Communication (transfer)

DTC Description DTC DETECTION LOGICWhen the ignition switch is ON, TCM is unable to receive the CAN communications signal from AWD control unit continuously for 2 seconds or more. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0102 LOST COMM (TRANSFER) (Lost Communication With Transfer Case Control Module) Diagnosis condition When the ignition switch is ON Signal CAN communication signal Threshold TCM is unable to receive the CAN communications signal from AWD control unit Diagnosis delay time Continuously for 2 seconds or more POSSIBLE CAUSE AWD control unit Harness or connector (CAN communication line is open or shorted) FAIL-SAFENot changed from normal driving DTC Confirmation Procedure PREPARATION BEFORE WORK If another “DTC CONFIRMATION PROCEDURE” occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test...