Nissan Murano: Interior Lighting System :: Removal and Installation / Vanity Lamp

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Controls / Interior Lighting System :: Removal and Installation / Vanity Lamp

Removal and Installation

CAUTION:

Do not attempt to separate the vanity lamp from the sun visor or damage to the components may occur.

The vanity lamp is serviced as part of the sun visor. Refer to Removal and Installation.

    Front Room/map Lamp Assembly

    Exploded View 1. Headlining 2. Front room/map lamp assembly bracket (without panoramic roof glass) 3. Front room/map lamp assembly bracket (with panoramic roof glass) 4...

    Glove Box Lamp

    Removal and Installation WARNING: Do not touch bulb while it is lit or right after being turned OFF. Burning may result. CAUTION: Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: P2271 Ho2s2


    DTC Description DTC DETECTION LOGICThe heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold) causes the longer switching time...

    Nissan Murano (Z52) 2015-2024 Service Manual: Component Parts. Driveline System


    Component Parts Location A. Inside storage room B. Rear final drive No. Component Function 1. Steering angle sensor Mainly transmits the following signal to AWD control unit via CAN communication: Steering angle sensor signal Refer to Component Parts Location for detailed component location...

    Categories

    LATCH (Lower Anchors and Tethers for CHildren) system

    Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

    LATCH system lower anchor locations - bench seat

    Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.

    read more

     
    Copyright © 2026 www.nimurano.com