Nissan Murano: How to use the remote keyless entry function / Using the interior light
Press the 
button on the
Intelligent
Key once to turn on the interior lights.
For additional information, refer to “Interior
lights” in the “Instruments and controls”
section of this manual.
Using the panic alarm
If you are near your vehicle and feel threatened,
you may activate the panic alarm to
call attention by pressing and holding
the button on the Intelligent Key
for
longer than 1 second...
Answer back horn feature
If desired, the answer back horn feature
can be deactivated using the Intelligent
Key. When it is deactivated and the
button is pushed, the hazard indicator
lights flash twice...
Other information:
Nissan Murano (Z52) 2015-2024 Owners Manual: Replacing
Replace the wiper blades if they are worn. To replace the windshield wiper blades, follow the procedure below: Lift the wiper arm away from the windshield. Lift the release tab . Move the wiper blade down and remove. Insert the new wiper blade onto the wiper arm...
Nissan Murano (Z52) 2015-2024 Service Manual: Service Data and Specifications (sds). Service Data and Specifications (sds)
Idle Speed Condition Specification No load* (in P or N position) 625 ± 50 rpm *: Under the following conditions A/C switch: OFF Electric load: OFF (Lights, heater fan & rear window defogger) Steering wheel: Kept in straight-ahead position Ignition Timing Condition Specification No load* (in P or N position) 12 ± 2° BTDC *: Under the following conditions A/C switch: OFF Electric load: OFF (Lights, heater fan & rear window defogger) Steering wheel: Kept in straight-ahead position Calculated Load Value Condition Specification (Using CONSULT or GST) At idle 10 – 35 % At 2,500 rpm 10 – 35 % Mass Air Flow Sensor Supply voltage Approx...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Rear bench seat adjustment
- System malfunction
- How to enable/disable the LDW system
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
