Nissan Murano: Automatic Drive Positioner :: Dtc/circuit Diagnosis / U1010 Control Unit(can)

Nissan Murano (Z52) 2015-2024 Service Manual / Body Interior / Automatic Drive Positioner :: Dtc/circuit Diagnosis / U1010 Control Unit(can)

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC Detection Condition
U1010	CONTROL UNIT(CAN) [Control unit (CAN)]	Diagnosis condition	When ignition switch ON.
		Signal (terminal)	—
		Threshold	—
		Diagnosis delay time	2 seconds or more

POSSIBLE CAUSE

BCM

FAIL-SAFE

—

Diagnosis Procedure

REPLACE DRIVER SEAT CONTROL UNIT

When DTC "U1010" is detected, replace driver seat control unit.

Replace driver seat control unit. Refer to Removal and Installation.

U1000 Can Comm Circuit

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition U1000 CAN COMM CIRCUIT (CAN communication circuit) Diagnosis condition When ignition switch ON...

B2112 Seat Slide

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition B2112 SEAT SLIDE (Seat slide) Diagnosis condition When ignition switch ON...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: B242e Hands Free Sensor 2

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B242E HANDS FREE SENOR 2 (Kick sensor 2) Diagnosis condition All times Signal (terminal) – Threshold BCM detects the abnormal resistance value of motion activated back door sensor (upper) via serial communication Diagnosis delay time – POSSIBLE CAUSE Motion activated back door sensor (upper) Harness or connectors [motion activated back door sensor (upper) circuit is open or shorted] BCM Motion activated back door control unit FAIL-SAFEInhibit motion activated automatic back door system DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...

Nissan Murano (Z52) 2015-2024 Service Manual: A-Bag Branch Line Circuit

Diagnosis Procedure WARNING: Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait 3 minutes or more. (To discharge backup capacitor.) Never use unspecified tester or other measuring device. CHECK CONNECTOR Turn the ignition switch OFF...