Nissan Murano: Automatic Drive Positioner :: Dtc/circuit Diagnosis / U1000 Can Comm Circuit

Nissan Murano (Z52) 2015-2024 Service Manual / Body Interior / Automatic Drive Positioner :: Dtc/circuit Diagnosis / U1000 Can Comm Circuit

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition
U1000

CAN COMM CIRCUIT

(CAN communication circuit)
Diagnosis condition When ignition switch ON.
Signal (terminal) —
Threshold —
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

—

DTC Confirmation Procedure

STEP 1

Ignition switch ON and wait at least 2 seconds.

>>

GO TO 2.

STEP 2

CONSULT

  1. Select “Self Diagnostic Result” mode of “AUTO DRIVE POS.”.

  2. Check DTC.

Is the DTC detected?

YES>>

Perform diagnosis procedure. Refer to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

SELF DIAGNOSTIC RESULT

CONSULT

  1. Ignition switch ON and wait for 2 seconds or more.

  2. Select “Self Diagnostic Result” mode of “AUTO DRIVE POS.”.

  3. Check DTC.

Is DTC “U1000” displayed?

YES>>

Refer to Trouble Diagnosis Flow Chart.

NO>>

GO TO 2.

CHECK INTERMITTENT INCIDENT

Refer to Intermittent Incident.

>>

Inspection End.

    Automatic Drive Positioner :: Dtc/circuit Diagnosis

    ..

    U1010 Control Unit(can)

    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition U1010 CONTROL UNIT(CAN) [Control unit (CAN)] Diagnosis condition When ignition switch ON...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Light Reminder Warning


    Light Reminder Warning SYSTEM DIAGRAMWARNING CHIME OPERATION CONDITIONSIf all of the following conditions are fulfilled: Operation conditions Ignition switch OFF Combination switch (Lighting switch) 1st or 2nd position Driver side door Open [front door switch LH ON] WARNING CHIME CANCEL CONDITIONSWarning is canceled if any of the following conditions are fulfilled: Operation conditions Ignition switch ON Combination switch (Lighting switch) OFF or AUTO position Driver side door Close [front door switch LH OFF] SIGNAL PATH BCM requires warning chime output to combination meter when it judges light reminder warning chime is necessary from signals below...

    Nissan Murano (Z52) 2015-2024 Owners Manual: LDW system limitations


    WARNING Listed below are the system limitations for the LDWsystem. Failure to follow the warnings and instructions for proper use of the LDW system could result in serious injury or death. The system will not operate at speeds below approximately 37mph(60 km/h) or if it cannot detect lane markers...

    Categories

    LATCH (Lower Anchors and Tethers for CHildren) system

    Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

    LATCH system lower anchor locations - bench seat

    Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.

    read more

     
    Copyright © 2026 www.nimurano.com