Nissan Murano: Dtc/circuit Diagnosis / U0100 Lost Communication (ecm A)

Nissan Murano (Z52) 2015-2024 Service Manual / Transmission & Driveline / Transaxle & Transmission :: Cvt: Re0f10j / Dtc/circuit Diagnosis / U0100 Lost Communication (ecm A)

DTC Description

DTC DETECTION LOGIC

When the ignition switch is ON, TCM is unable to receive the CAN communications signal from ECM continuously for 2 seconds or more.

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
U0100	LOST COMM (ECM A) (Lost Communication With ECM/PCM A)	Diagnosis condition	When the ignition switch is ON
		Signal	CAN communication signal
		Threshold	TCM is unable to receive the CAN communications signal from ECM
		Diagnosis delay time	Continuously for 2 seconds or more

POSSIBLE CAUSE

ECM
Harness or connector (CAN communication line is open or shorted)

FAIL-SAFE

Selector shock is large
Start is slow
Acceleration is slow
Lock-up is not performed

DTC Confirmation Procedure

CHECK DTC PRIORITY

WhenDTC U0100 is displayed together with DTC U0300, diagnose first the DTC U0300.

Is "U0300" detected?

YES>>

Perform diagnosis of DTC U0300. Refer to Diagnosis Procedure.

NO>>

GO TO 2.

PREPARATION BEFORE WORK

If another “DTC CONFIRMATION PROCEDURE” occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE

Start the engine and wait for at least 5 seconds.
Check the DTC.

Is “U0100” detected?

YES>>

Go to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

For the diagnosis procedure, refer to Trouble Diagnosis Flow .

U0073 Communication Bus a Off

DTC Description DTC DETECTION LOGICTCM communication blockage lasts for 2 seconds or more when turning ON the ignition switch. (Communication not established...

U0102 Lost Communication (transfer)

DTC Description DTC DETECTION LOGICWhen the ignition switch is ON, TCM is unable to receive the CAN communications signal from AWD control unit continuously for 2 seconds or more...

Other information:

Nissan Murano (Z52) 2015-2024 Owners Manual: Reporting safety defects

For USA If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying NISSAN. If NHTSA receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may order a recall and remedy campaign...

Nissan Murano (Z52) 2015-2024 Service Manual: Ecu Diagnosis Information. Adas Control Unit 2

Values on the Diagnosis Tool NOTE: The following table includes information (items) inapplicable to this Nissan Murano vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. Monitor item Condition Value/Status MAIN SW Ignition switch ON When MAIN switch is pressed On When MAIN switch is not pressed Off SET/COAST SW Ignition switch ON When SET/COAST switch is pressed On When SET/COAST switch is not pressed Off CANCEL SW Ignition switch ON When CANCEL switch is pressed On When CANCEL switch is not pressed Off RESUME/ACC SW Ignition switch ON When RESUME/ACCELERATE switch is pressed On When RESUME/ACCELERATE switch is not pressed Off DISTANCE SW Ignition switch ON When DISTANCE switch is pressed On When DISTANCE switch is not pressed Off CRUISE OPE Drive the Nissan Murano vehicle and activate the vehicle-to-vehicle distance control mode When ICC system is controlling On When ICC system is not controlling Off BRAKE SW Ignition switch ON When brake pedal is depressed Off When brake pedal is not depressed On STOP LAMP SW Ignition switch ON When brake pedal is depressed On When brake pedal is not depressed Off IDLE SW Engine running Idling On Except idling (depress accelerator pedal) Off VHCL SPEED SE While driving Displays the Nissan Murano vehicle speed calculated by ADAS control unit ENGINE RPM Engine running Equivalent to tachometer reading THRTL SENSOR NOTE: The item is displayed, but it is not used...