Nissan Murano: Dtc/circuit Diagnosis / U0073 Communication Bus a Off
DTC DETECTION LOGIC
TCM communication blockage lasts for 2 seconds or more when turning ON the ignition switch. (Communication not established.)
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | |
| U0073 |
COMM BUS A OFF (Control Module Communication Bus A Off) |
Diagnosis condition | When turning ON the ignition switch |
| Signal | CAN communication | ||
| Threshold | TCM communication blockage (Communication not established) | ||
| Diagnosis delay time | Last for 2 seconds or more | ||
POSSIBLE CAUSE
Harness or connector (CAN communication line is error)
FAIL-SAFE
-
Selector shock is large
-
Start is slow
-
Acceleration is slow
-
Lock-up is not performed
PREPARATION BEFORE WORK
If another “DTC CONFIRMATION PROCEDURE” occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
-
Start the engine and wait for at least 5 seconds.
-
Check the DTC.
Is “U0073” detected?
YES>>Go to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
For the diagnosis procedure, refer to Trouble Diagnosis Flow .
U0100 Lost Communication (ecm A)
DTC Description
DTC DETECTION LOGICWhen the ignition switch is ON, TCM is unable to receive the CAN communications signal from ECM continuously for 2 seconds or more...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: U1232 Steering Angle Sensor
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1232 ST ANGLE SEN CALIB (Steering angle sensor calibration) Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold — Diagnosis delay time — POSSIBLE CAUSE Neutral position adjustment of the steering angle sensor is incomplete Steering angle sensor FAIL-SAFEPredictive course line is not displayed DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...
Nissan Murano (Z52) 2015-2024 Service Manual: Rear Washer Tube
Removal and Installation REMOVALRemove the luggage side lower finisher (RH). Refer to Removal and Installation. Remove the center pillar lower finisher (RH). Refer to Removal and Installation. Release clips using a suitable tool and remove rear seat belt center retractor finisher...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Memory storage function (key-link)
- All-Wheel Drive (AWD) (if so equipped)
- High Beam Assist (if so equipped)
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.