Nissan Murano: Roof :: Symptom Diagnosis / Retained Power Operation Does Not Operate Properly

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Roof :: Symptom Diagnosis / Retained Power Operation Does Not Operate Properly

Diagnosis Procedure

CHECK FRONT DOOR SWITCH

Check (LH and RH) front door switches.

Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace the malfunctioning parts.

CONFIRM THE OPERATION

Confirm the operation again.

Is the inspection result normal?

YES>>

Check intermittent incident. Refer to Intermittent Incident.

NO>>

GO TO 1.

Sunshade

Diagnosis Procedure CHECK SUNSHADE MECHANISM Check the following: Operation malfunction caused by sunshade mechanism deformation, pinched harness or other foreign materials ...

Squeak and Rattle Trouble Diagnoses

Work Flow CUSTOMER INTERVIEWInterview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any customer's comments; refer to Diagnostic Worksheet...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: B130b Rear Right Speaker

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B130B–13 Rear RH speaker (Rear door speaker RH) [OPEN] Diagnosis condition When ignition switch is ON. Signal (terminal) RR SP RH+ (terminal 13) RR SP RH− (terminal 14) Threshold – Diagnosis delay time 30 seconds or more B130B–1C [SHORT] Diagnosis condition When ignition switch is ON...

Nissan Murano (Z52) 2015-2024 Service Manual: Light Reminder Warning

Light Reminder Warning SYSTEM DIAGRAMWARNING CHIME OPERATION CONDITIONSIf all of the following conditions are fulfilled: Operation conditions Ignition switch OFF Combination switch (Lighting switch) 1st or 2nd position Driver side door Open [front door switch LH ON] WARNING CHIME CANCEL CONDITIONSWarning is canceled if any of the following conditions are fulfilled: Operation conditions Ignition switch ON Combination switch (Lighting switch) OFF or AUTO position Driver side door Close [front door switch LH OFF] SIGNAL PATH BCM requires warning chime output to combination meter when it judges light reminder warning chime is necessary from signals below...