Nissan Murano: Maximum load limits / Trailer frontal area

Nissan Murano (Z52) 2015-2024 Owners Manual / Technical and consumer information / Towing a trailer / Maximum load limits / Trailer frontal area

CAUTION

Exceeding the maximum trailer frontal area specification may exceed the towing capacity of the vehicle. This may affect the towing performance and lead to vehicle damage.

The trailer frontal area affects the towing load of a trailer. The frontal area is the total area of the vehicle and trailer that is affected by air resistance while towing. Do not exceed the maximum trailer frontal area specification shown in the "Towing Load/Specification” chart. The frontal area can be determined by multiplying the width of the trailer by the height of the trailer. For example, a trailer that is 8 feet wide by 6 feet tall has a trailer frontal area of 48 square feet.

Maximum Gross Vehicle Weight (GVW)/maximum Gross Axle Weight (GAW)

The GVW of the towing vehicle must not exceed the Gross Vehicle Weight Rating (GVWR) shown on the F.M.V.S.S./C.M.V.S.S. certification label. The GVW equals the combined weight of the unloaded vehicle, passengers, luggage, hitch, trailer tongue load and any other optional equipment...

Towing load/specification

WARNING The towing capacities provided in this manual are for general reference only. The safe towing capacity of your vehicle is affected by dealer and factory installed options and passenger and cargo loads...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Door Lock and Unlock Switch. Driver Side

Component Function Check CHECK FUNCTION CONSULT Select “CDL LOCK SW” or “CDL UNLOCK SW” in “Data Monitor” mode of “BCM(DOOR LOCK)”. Check that the function operates normally according to the following conditions: Monitor Item Condition Status CDL LOCK SW Door lock and unlock switch Lock ON Unlock OFF CDL UNLOCK SW Lock OFF Unlock ON Is the inspection result normal? YES>> Door lock and unlock switch is OK...

Nissan Murano (Z52) 2015-2024 Service Manual: Diagnosis and Repair Workflow

Work Flow OVERALL SEQUENCE *1: Include 1st trip DTC. *2: Include 1st trip freeze frame data. DETAILED FLOWGET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred) using the “Diagnostic Work Sheet”...