Nissan Murano: Tire Pressure Monitoring System (TPMS) / TPMS with Easy-Fill Tire Alert

When adding air to an under-inflated tire, the TPMS with Easy-Fill Tire Alert provides visual and audible signals outside the vehicle to help you inflate the tires to the recommended COLD tire pressure.

Vehicle set-up

1. Park the vehicle in a safe and level place.
2. Apply the parking brake and place the shift lever in the P (Park) position.
3. Place the ignition switch in the ON position. Do not start the engine.

Operation

1. Add air to the tire.
2. After a few seconds, the hazard indicators will start flashing.
3. When the designated pressure is reached, the horn beeps once and the hazard indicators stop flashing.
4. Perform the above steps for each tire.
   • If the tire is over-inflated more than approximately 4 psi (30 kPa), the horn beeps and the hazard indicators flash three times. To correct the pressure, push the core of the valve stem on the tire briefly to release pressure. When the pressure reaches the designated pressure, the horn beeps once.
   • If the hazard indicator does not flash within approximately 15 seconds after starting to inflate the tire, it indicates that the Easy-Fill Tire Alert is not operating.
   • The TPMS will not activate the Easy- Fill Tire Alert under the following conditions:
     • If there is interference froman external device or transmitter.
     • The air pressure from the inflation device is not sufficient to inflate the tire.
     • There is a malfunction in the TPMS.
     • There is a malfunction in the horn or hazard indicators.
     • The identification code of the tire pressure sensor is not registered to the system.
     • The battery of the tire pressure sensor is low.
   • If the Easy-Fill Tire Alert does not operate due to TPMSinterference,move the vehicle about 3 ft (1 m) backward or forward and try again.

If the Easy-Fill Tire Alert is not working, use a tire pressure gauge.