Nissan Murano: Inspection and Adjustment / System Setting

Nissan Murano (Z52) 2015-2024 Service Manual / Body Interior / Automatic Drive Positioner :: Basic Inspection / Inspection and Adjustment / System Setting

Description

The settings of the automatic drive positioner system can be changed using CONSULT, the display unit in the center of the instrument panel and the set switch. Always check the settings before and after disconnecting the battery terminal or replacing driver seat control unit.

Setting Change

×: Applicable

Item	Content	CONSULT	Set switch	Factory setting
Amount of seat sliding for entry/exit assist	The amount of seat sliding for entry/exit assist can be selected from 3 items. [40 mm/80 mm/150 mm]	x	—	40 mm
Entry/exit assist (seat)	Entry/exit assist (seat) can be selected: ON (operated) – OFF (not operated)	x	x	ON
Entry/exit assist (steering column)	Entry/exit assist (steering column) can be selected: ON (operated) – OFF (not operated)	x	x	ON

Work Procedure

CHOOSE METHOD

There are two setting methods.

Which method do you choose?

With CONSULT>>

GO TO 2.

With set switch>>

GO TO 4.

WITH CONSULT - STEP 1

CONSULT

Select “Work support” mode of “AUTO DRIVE POS.”.

GO TO 3.

WITH CONSULT - STEP 2

CONSULT

Select the “EXIT SEAT SLIDE SETTING” or “EXIT TILT SETTING” in “Work support” mode of “AUTO DRIVE POS.”, then touch display to change between ON and OFF.
- EXIT SEAT SLIDE SETTING: Entry/exit assist (seat)
- EXIT TILT SETTING: Entry/exit assist (steering column)
Select the “SEAT SLIDE VOLUME SET” in “Work support” mode of “AUTO DRIVE POS.” and touch either “40 mm”, “80 mm”, or “150 mm”.
Then touch “OK”.

Inspection End.

WITH SET SWITCH - STEP 1

Ignition switch OFF.

GO TO 5.

WITH SET SWITCH - STEP 2

Push set switch and hold for more than 10 seconds then confirm blinking of the memory switch indicator.

Entry/exit assist (seat/steering column) is ON: Memory switch indicator blinks two times.
Entry/exit assist (seat/steering column) is OFF: Memory switch indicator blinks once.

Inspection End.

Linking Key Fob to the Meter Display

Description Always perform when the battery terminal is disconnected or the driver seat control unit is replaced. Linking key fob to the meter display will not operate normally if no memory storage is performed...

Automatic Drive Positioner :: Dtc/circuit Diagnosis

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: C1143 St Ang Sen Circuit

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1143 ST ANG SEN CIRCUIT (Steering angle sensor circuit) Diagnosis condition When ignition switch ON. Signal (terminal) Steering angle sensor signal Threshold Steering angle sensor signal failure Diagnosis delay time 2 seconds or more POSSIBLE CAUSE Harness or connectors Steering angle sensor Power steering control module FAIL-SAFECertain steering assist force DTC Confirmation Procedure PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test...

Nissan Murano (Z52) 2015-2024 Service Manual: Ecm

Exploded View 1. ECM bracket 2. ECM 3. ECM cover Front Removal and Installation CAUTION: Perform ADDITIONAL SERVICE WHEN REPLACING ECM. Refer to Description. REMOVALRemove front air duct. Refer to Removal and Installation...