Nissan Murano: Engine / Starting System :: Service Data and Specifications (sds). Starter Motor
Starter
|
Application
|
VQ35DE |
| CVT model |
| Type* |
Mitsubishi M000TB0272ZC |
| Reduction gear type |
| System voltage |
12V |
| No-load |
Terminal voltage |
11V |
| Current |
Less than 90A |
| Revolution |
More than 2,370 rpm |
| Movement "L" in height of pinion assembly |
0.3 - 2.5 mm (0.012 - 0.098 in) |
*: Always check with the Parts Department for the latest parts information.
Exploded View
1.
Cylinder block
2.
Shim
3.
Starter
4.
"B" terminal harness
5.
"S" connector
Removal and Installation
NOTE:
When removing components such as hoses, tubes/ lines, etc...
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...
Other information:
Values on the Diagnosis Tool
Monitor item Condition Value/Status
VHCL SPEED SE
While driving
Value of Nissan Murano vehicle speed signal (wheel speed)
YAW RATE
While driving
Nissan Murano Vehicle stopped
0.0
Nissan Murano Vehicle turning right
Positive value
Nissan Murano Vehicle turning left
Negative value
PWR SUP MONI
Ignition switch ON
Power supply voltage value of distance sensor (ICC sensor)
DISTANCE
Drive the Nissan Murano vehicle and activate the ICC system...
Exploded View
1.
Engine assembly
2.
Front timing chain case oil filter
3.
Water pump cover
4.
Crankshaft pulley
5.
Front oil seal
6.
Front timing chain case
7.
O-ring
A.
To valve timing control cover (bank 1/bank 2). Refer to Valve Timing Control Cover (bank 1) and Valve Timing Control Cover (bank 2)...
Categories

The autolight system allows the headlights
to turn on and off automatically. The autolight
system can:
Turn on the headlights, front parking,
tail, license plate and instrument panel
lights automatically when it is dark.
Turn off all the lights (except daylight
running lights) when it is light.
Keep all the lights on for a period of time
after you place the ignition switch in the
OFF position and all doors are closed.
read more