Nissan Murano: Engine Maintenance (vq35de) / Spark Plug

Nissan Murano (Z52) 2015-2024 Service Manual / Maintenance / Maintenance :: Periodic Maintenance / Engine Maintenance (vq35de) / Spark Plug

Exploded View

1. Ignition coil 2. Spark plug 3. Rocker cover (RH)
4. Rocker cover (LH) Front
Removal and Installation

REMOVAL

Remove the ignition coil. Refer to Removal and Installation (bank 2) and Removal and Installation (bank 1).

Remove the spark plug with Tool.

Tool number : — (J-48891)

INSPECTION AFTER REMOVAL

Use the standard type spark plug for normal condition.

Spark plug : Refer to Spark Plug.

CAUTION:

  • Do not drop or shock spark plug. Discard spark plug if dropped.

  • Do not use a wire brush for cleaning.

  • If plug is covered with carbon, a spark plug cleaner may be used.

Cleaner air pressure : less than 588 kPa (6 kg/cm2, 85 psi)
Cleaning time : less than 20 seconds
  • Spark plug gap adjustment is not required between replacement intervals.

  • Measure spark plug gap. When it exceeds the limit, replace spark plug even if it is within the specified replacement mileage. Refer to Spark Plug.

INSTALLATION

Installation is in the reverse order of removal.

Make DENSO
Standard type* FXE22HR11
Gap (nominal) 1.1 mm (0.043 in)

*: Always check with the Parts Department for the latest parts information.

    Air Cleaner Filter

    Exploded View 1. Air duct hose and resonator assembly 2. Front air duct 3. Grommet 4. Air cleaner case (lower) 5. Grommets 6. Air cleaner case mounting bracket 7...

    Engine Coolant

    System Inspection WARNING: Do not remove the radiator cap or reservoir tank cap when the engine is hot. Serious burns could occur from high-pressure engine coolant escaping from the cooling system...

    Other information:

    Nissan Murano (Z52) 2015-2024 Owners Manual: Brake precautions


    Vacuum assisted brakes The brake booster aids braking by using engine vacuum. If the engine stops, you can stop the vehicle by depressing the brake pedal. However, greater foot pressure on the brake pedal will be required to stop the vehicle and stopping distance will be longer...

    Nissan Murano (Z52) 2015-2024 Service Manual: Back Door Touch Sensor


    Removal and Installation CAUTION: Use care not to bend touch sensor. Replace the back door touch sensor if it has been dropped or sustained an impact. REMOVALRelease touch sensor clips using a suitable tool. Disconnect the harness connector from the touch sensor and remove...

    Categories

    Luggage hooks

    Nissan Murano. Luggage hooks

    When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs. (29 N) to a single hook.

    The luggage hooks that are located on the floor should have loads less than 110 lbs. (490 N) to a single hook.

    read more

     
    Copyright © 2026 www.nimurano.com