Nissan Murano: Engine Maintenance (vq35de) / Air Cleaner Filter

Nissan Murano (Z52) 2015-2024 Service Manual / Maintenance / Maintenance :: Periodic Maintenance / Engine Maintenance (vq35de) / Air Cleaner Filter

Exploded View

1.	Air duct hose and resonator assembly	2.	Front air duct	3.	Grommet
4.	Air cleaner case (lower)	5.	Grommets	6.	Air cleaner case mounting bracket
7.	Bracket	8.	Air cleaner filter	9.	Air cleaner case (upper)
10.	Mass air flow sensor	A.	Air cleaner case side clips	B.	To electric throttle control actuator. Refer to Exploded View.
	Front

Removal and Installation

REMOVAL

CAUTION:

It is not necessary to remove the front air duct to replace the air cleaner filter.

NOTE:

Replace the air cleaner filter per the periodic maintenance schedule or as necessary. Refer to Introduction of Periodic Maintenance.

Unhook air cleaner case side clips and lift air cleaner case (upper).

Remove the air cleaner filter.

INSTALLATION

Installation is in the reverse order of removal.

Drive Belts

Exploded View 1. Drive belt auto-tensioner 2. Generator 3. A/C compressor 4. Drive belt 5. Crankshaft pulley A. Indicator B...

Spark Plug

Exploded View 1. Ignition coil 2. Spark plug 3. Rocker cover (RH) 4. Rocker cover (LH) Front Removal and Installation REMOVALRemove the ignition coil...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Symptom Diagnosis. Cvt Control System

Symptom Table The diagnosis item number indicates the order of check. Start checking in the order from 1. Perform diagnoses of symptom table 1 before symptom table 2. Symptom Table 1 Symptom Engine system CAN communication line Transmission range switch (P0705, P0706) Input speed sensor (P0715, P0716, P0717) Primary speed sensor (P0791, P0792, P0793) Secondary speed sensor (P2765, P2766, P2767) CVT fluid temperature sensor (P0711, P0712, P0713) Primary pressure sensor (P084C, P084D) Secondary pressure sensor (P0841, P0847, P0848) Torque converter clutch solenoid valve (P0740, P0743, P0744) Manual mode switch Stall test CVT position Power supply Control valve CVT fluid level and state Ignition switch and starter Work Flow DTC Index Work Procedure Inspection and Adjustment Diagnosis Procedure Removal and Installation (front wheel drive) or Removal and Installation (all wheel drive) Inspection Wiring Diagram, Wiring Diagram - IGNITION POWER SUPPLY - Shift Shock Large shock (N→ D position) 1 4 8 3 6 2 9 5 Large shock (N→ R position) 1 4 8 3 6 2 9 5 Shock is too large for lock-up...

Nissan Murano (Z52) 2015-2024 Service Manual: Telematics Switch

Removal and Installation REMOVALRemove the map lamp assembly. Refer to Removal and Installation. Remove the connector and screws . Remove the telematics switch with the map lamp assembly finisher as a single unit from the map lamp assembly. Remove the telematics switch , stretching pawls of the map lamp assembly finisher ...