Nissan Murano: Mirrors :: Removal and Installation / Side Camera Finisher

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Controls / Mirrors :: Removal and Installation / Side Camera Finisher

Removal and Installation

The side camera finisher (if equipped) is serviced as part of the door mirror rear finisher. Refer to Removal and Installation.

    Door Mirror Actuator

    Removal and Installation REMOVALRemove door mirror glass. Refer to Removal and Installation. Remove screw (A) from door mirror actuator (1). Disconnect harness connector from door mirror actuator and remove...

    Main Power Window and Door Mirror Switch

    Removal and Installation REMOVALRemove main power window and door lock/unlock switch finisher. Refer to Removal and Installation. Release pawls and remove door mirror remote control switch (1) from main power window and door lock/unlock switch finisher (2)...

    Other information:

    Nissan Murano (Z52) 2015-2024 Owners Manual: Floor mats (if so equipped)


    WARNING To avoid potential pedal interference that may result in a collision, injury or death: NEVER place a floor mat on top of another floor mat in the driver front position or install them upside down or backwards. Use only Genuine NISSAN floor mats, or equivalent floor mats, that are specifically designed for use in your vehicle model and model year...

    Nissan Murano (Z52) 2015-2024 Service Manual: Diagnosis System (tcm). Diagnosis Description


    1 Trip Detection Diagnosis and 2 Trip Detection Diagnosis NOTE: “Start the engine and turn OFF the ignition switch after warm-up.” This is defined as 1 trip. 1 TRIP DETECTION DIAGNOSISWhen initial malfunction is detected, TCM memorizes DTC. In these diagnoses, some illuminate MIL and some do not...

    Categories

    LATCH (Lower Anchors and Tethers for CHildren) system

    Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

    LATCH system lower anchor locations - bench seat

    Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.

    read more

     
    Copyright © 2026 www.nimurano.com