Nissan Murano: Security Control System :: Symptom Diagnosis / Intelligent Key System Symptoms

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Security Control System :: Symptom Diagnosis / Intelligent Key System Symptoms

Diagnosis Procedure

NOTE:

Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected.

SYMPTOM TABLE 1 (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS)


No.	Door lock operation (remote keyless entry)	Door lock operation (request switch) or back door open operation (opener switch of back door panel)	Engine started with ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna)	Engine started with ignition switch operation (registered Intelligent Key placed next to ignition switch)	Symptom
1	OK	OK	No start	No start	Diagnosis Procedure
2	OK	NG	OK	OK	Diagnosis Procedure
3	OK	NG	No crank, No start	OK	Diagnosis Procedure
4	NG	NG	No crank, No start	OK	Diagnosis Procedure
5	NG	NG	No start	No start	Diagnosis Procedure
6	OK	OK	No crank, No start	OK	Diagnosis Procedure
7	NG	OK	OK	OK	Diagnosis Procedure
8	NG	NG	OK	OK	Diagnosis Procedure
9	Poor range	OK	OK	OK	Diagnosis Procedure

SYMPTOM TABLE 2 (ONE INTELLIGENT KEY HAS THE SYMPTOM, OTHER KEYS OPERATE NORMALLY)


No.	Door lock operation (remote keyless entry)	Door lock operation (request switch) or back door open operation (opener switch of back door panel)	Engine started with ignition switch operation (Intelligent Key is within the detection area of inside key antenna)	Engine started with ignition switch operation (registered Intelligent Key placed next to ignition switch)	Symptom
1	NG	OK	OK	OK	Diagnosis Procedure
2	NG	NG	No crank, No start	OK	Diagnosis Procedure
3	NG	NG	No crank, No start	No crank, No start	Diagnosis Procedure
4	OK	OK	No crank, No start	No crank, No start	Diagnosis Procedure
5	OK	NG	No crank, No start	OK	Diagnosis Procedure
6	Poor range	OK	OK	OK	Diagnosis Procedure

Security Control System :: Symptom Diagnosis

Engine Can Not Start

Diagnosis Procedure Engine does not start when ignition switch is pressed.SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (remote keyless entry) Door lock operation (request switch) or back door open operation (opener switch of back door panel) Engine started with push-button ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) OK OK No start No start CONDITIONS OF VEHICLE (OPERATING CONDITIONS)“ENGINE START BY I-KEY” setting in “Work support” mode of “BCM(INTELLIGENT KEY)” is ON...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Ring Gear Shaft

Exploded View Oil seal Transfer cover Filler plug Gasket Drain plug Oil seal O-ring Ring gear bearing adjusting shim (transfer cover side) Ring gear bearing (transfer cover side) Drive shaft oil seal Ring gear shaft Ring gear bearing (transfer case side) Ring gear bearing adjusting shim (transfer case side) Ring gear Baffle plate Transfer case Plug O-ring Oil seal Dowel pin Drive pinion Drive pinion adjusting shim O-ring Pinion bearing assembly Oil seal Dust cover Companion flange Pinion lock nut Oil seal lip Comply with the assembly procedure when tightening...

Nissan Murano (Z52) 2015-2024 Service Manual: Diagnosis and Repair Work Flow

Work Flow NOTE: “DTC” includes DTC at the 1st trip. OBTAIN INFORMATION ABOUT SYMPTOM Refer to Diagnostic Work Sheet and interview the customer to obtain the malfunction information (conditions and environment when the malfunction occurred) as much as possible when the customer brings in the Nissan Murano vehicle...